User manual HUSQVARNA HU 9027 ST A

[. . . ] 9027ST Owner's Manual SAFETY RULES Safe Operation Practices for Snow Throwers IMPORTANT: This machine is capable of amputating hands and feet and throwing objects. Failure to observe the following safety instructions could result in serious injury or death. • Do not operate the equipment without wearing adLook for this symbol to point out imequate winter outer garments. It means clothing, such as scarves, which can get caught in CAUTION!!! [. . . ] Disconnect the power cord from the receptacle first, then from the engine. Engine will not develop full power until it has reached normal operating temperature. WARM START - ELECTRIC STARTER Follow the steps above, keeping the choke control in the OFF position. Push the primer four (4) times if the temperature is below 15°F, or two (2) times if temperature is between 15° and 50°F. NOTE: Over priming may cause flooding, preventing the engine from starting. If you do flood the engine, wait a few minutes before attempting to start and DO NOT push the primer. When the engine starts, release the recoil starter handle and slowly move the choke control to the OFF position. Engine will not develop full power until it has reached normal operating temperature. WARM START - RECOIL STARTER Follow the steps above, keeping the choke in the OFF position. BEFORE STOPPING Run the engine for a few minutes to help dry off any moisture on the engine. To avoid possible freeze-up of the starter, proceed as follows: 13 ELECTRIC STARTER 1. Plug the other end of the power cord into a three-hole grounded 120 Volt A. C. While the engine is running, push starter button and spin the starter for several seconds. NOTE: The unusual sound made while starter is spinning will not harm the engine or starter. Disconnect the power cord from the receptacle first, then from the engine. While the engine is running, pull the recoil starter handle with rapid, full arm strokes three or four times. NOTE: The unusual sound made while pulling the recoil starter handle will not harm the engine or starter. IF RECOIL STARTER HAS FROZEN If the recoil starter has frozen and will not turn the engine, proceed as follows: 1. Grasp the recoil starter handle and slowly pull as much rope out of the starter as possible. Release the recoil starter handle and let it snap back against the starter. If the engine still fails to start, repeat the above steps or use the electric starter. SNOW THROWING TIPS • • • • Always operate the snow thrower with the engine at full throttle. It is easier and more efficient to remove snow immediately after it falls. [. . . ] inches 1 inch = 25. 4 mm 27 REPAIR PARTS CHASSIS / ENGINE / PULLEYS SNOW THROWER - MODEL NO. 954 22 30-74 30 3 17 19 22 4 31 29 55 31 38 11 36 32 33 34 55 37 39 42 43 11 6 41 52 44 35 50 11 49 44 26 51 26 12 40 14 8 9 1 20 6 16 2 6 7 18 6 10 21 23 28 6 10 21 24 25 26 27 7 13 15 11 53 54 11 45 48 46 47 28 REPAIR PARTS KEY PART NO. NO. CHASSIS / ENGINE / PULLEYS DESCRIPTION SNOW THROWER - MODEL NO. 954 22 30-74 532 18 10-44 Spring, Traction Idler 532 18 05-22 Pulley, Idler (2-1/4) --Engine, Tecumseh, Model Number OHSK90 (Order parts from Engine manufacturer) 4 874 78 05-20 Screw, Hex Head 5/16-18 x 1-1/4 6 532 05 92-89 Washer, Flat 7 873 93 05-00 Nut, Jam, Lock 5/16-18 8 532 17 53-30 Pin, Idler Pivot 9 532 17 90-92 V-Belt, Traction Drive 10 810 04 05-00 Washer, Lock 5/16 11 532 15 00-78 Screw, Hex Head 5/16-18 x 3/4 12 532 18 47-89 Arm & Bracket Assembly, Impeller Idler (Includes Key Nos. [. . . ]