User manual HUSQVARNA J-HANDLE SET 123 L

[. . . ] Read through the Operator`s Manual carefully and understand the content before using the machine. These instructions supplement the instructions that were included with the machine. Husqvarna AB has a policy of continuous product development and therefore reserves the right to modify the design and appearance of products without prior notice. [. . . ] Longer periods running at full throttle without loading the engine (that is without resistance, which the engine feels from the cutting equipment when trimming) can lead to serious engine damage. Neither the user of the tool or anyone else may attempt to remove the cut material while the engine is running or with the blade rotating as this can result in serious injury. Stop the engine and blade before you remove material that has wound around the blade as otherwise there is a risk of injury. Children, animals, onlookers and helpers should be kept outside the safety zone of 15 m. WARNING Only grass blades or trimmer heads/ plastic blades may be used when the Jhandle is fitted. Cutting equipment assembled incorrectly can result in serious and/or fatal personal injury. Note that the loop handle must be fitted between the arrows on the shaft. Attach the J-handle to the loop handle using the three screws, as shown. Under no circumstances may the cutting equipment be used without an approved guard fitted. If the wrong guard or a defective guard is fitted this can cause serious personal injury. Do not attach any blade to the unit without proper installation of all required parts. Failure to use the proper parts can cause the blade to fly off and seriously injure the operator and/or bystanders. Fitting the combination guard, grass blade and grass knife Hook the guard (A) onto the bracket on the shaft and secure with 1 bolt. Turn the blade axle until one of the holes in the drive disc aligns with the hole in the gear housing. Place the blade (D), support cup (E) and support flange (F) on the output axle. Hold the handle of the spanner as close to the blade guard as possible. [. . . ] Never use the machine without a guard or spray guard nor with a defective guard. Approved accessories J-handle Centre hole in blades Ø 25, 4 mm (1") Threaded blade axle M10 Grass blade Plastic knives Trimmer head Type Cutting attachment guard Art No. Placer la lame (D), la coupelle de support (E) et la bride de support (F) sur l'arbre sortant. [. . . ]