User manual HUSQVARNA J-HANDLE KIT 125 L

[. . . ] 1 J-handle 2 screws 1 harness 1 suspension ring 2 screws 1 grass blade 1 support cup 1 support flange 1 nut 1 socket spanner 1 transport guard Please read the operator's manual carefully and make sure you understand the instructions before using the machine. These instructions supplement the instructions that were included with the machine. for other procedures , please refer to the operating instructions for the machine. [. . . ] Avoid cutting with the area of the blade between the 12 o'clock and 3 o'clock positions. Because of the speed of rotation of the blade kickback can occur if you attempt to cut thick stems with this area of the blade. Sometimes branches or grass get caught between the guard and cutting attachment. The grass is cut down with a sideways, swinging movement, where the movement from right-to-left is the clearing stroke and the movement from left-to-right is the return stroke. If the blade is angled to the left when clearing grass, the grass will collect in a line, which makes it easier to collect, e. Reduce the risk of material wrapping around the blade by following these instructions: 1 2 Always work at full throttle. Stop the engine, unclip the harness and place the machine on the ground before you start to collect the cut material. Neither the operator of the machine nor anyone else may attempt to remove the cut material while the engine is running or the cutting equipment is rotating, as this can result in serious injury. Stop the engine and cutting equipment before you remove material that has wound around the blade shaft as otherwise there is a risk of injury. Children, animals, onlookers and helpers should be kept outside the safety zone of 15 m. Only grass blades/grass cutters or trimmer heads/plastic blades may be used when the J-handle is fitted. Note that the loop handle must be fitted between the arrows on the shaft. Attach the J-handle to the loop handle using the two screws, as shown. Place the blade (D), support cup (E) and support flange (F) on the output shaft. Hold the shaft of the spanner as close to the blade guard as possible. Make a final adjustment of the J-handle to give a comfortable working position. [. . . ] Centre hole in blades/cutters, Ø 25, 4 mm Terms Grass blade/ grass cutter Trimmer head Plastic blades Support cup Type Grass 255-4 1" (Ø 255 4-teeth) T25 Tricut Ø 300 mm Fixed Cutting attachment guard, Art. Check that the support flange is not cracked due to fatigue or due to being tightened too much. Check that the trimmer head and trimmer guard are not damaged or cracked. [. . . ]