User manual HUSQVARNA JET51

[. . . ] Stop the blade if the lawnmower has to be tilted for transportation when crossing surfaces other than grass, and when transporting the lawnmower to and from the area to be mowed. Never operate the lawnmower with defective guards, or without safety devices, for example deflectors and/or grass catchers, in place. Operating the engine at excessive speed may increase the hazard of personal injury. Start the engine or switch on the motor carefully according to instructions and with feet well away from the blade. [. . . ] Do not tilt the lawnmower when starting the engine or switching on the motor, except if the lawnmower has to be tilted for starting. In this case, do not tilt more than absolutely necessary and lift only the part which is away from the operator. Do not start the engine when standing in front of the discharge chute. Stop the engine and disconnect the spark plug wire: - before cleaning blockages or unclogging chute; - before checking, cleaning or working on the lawnmower; - after striking a foreign object. Inspect the lawnmower for damage and make repairs before restarting and operating the lawnmower; - if the lawnmower starts to vibrate abnormally (check immediately). Stop the engine: - whenever you leave the lawnmower; - before refuelling. Reduce the throttle setting during engine shut down and, if the engine is provided with a shut-off valve, turn the fuel off at the conclusion of mowing. Keep all nuts, bolts and screws tight to be sure the equipment is in safe working condition. Never store the equipment with petrol in the tank inside a building where fumes may reach an open flame or spark. Position cables as shown and secure with machine screw, washer and lock nut. Install rope guide into side of upper handle and secure with 1/4-20 locknut. Hold brake yoke down to upper handle and slowly pull out the starter rope until the rope will slip into loop of the rope guide. Place discharge guard on top of discharge opening of lawn mower housing. â· Place bracket on top of discharge guard, position bracket and guard on mower and secure with bolts and nuts supplied. NOTE: The foot guard must be installed for the safe operation of this machine. NOTE: The foot guard must be installed for the safe operation of this machine. Put grass catcher frame into grass bag with stiff part of bag on the bottom. The grass catcher is secured to the lawn mower housing when the rear door is lowered onto the grass catcher frame. [. . . ] Put grass catcher frame into grass bag with stiff part of bag on the bottom. The grass catcher is secured to the lawn mower housing when the rear door is lowered onto the grass catcher frame. To start a cold engine, push primer three (3) times before trying to start. This step is not usually necessary when starting an engine which has already run for a few minutes. [. . . ]