User manual HUSQVARNA K760 RESCUE

[. . . ] Operator′s manual K 760 K760 Rescue Please read the operator’s manual carefully and make sure you understand the instructions before using the machine. The machine can be a dangerous tool if used incorrectly or carelessly, which can cause serious or fatal injury to the operator or others. Please read the operator’s manual carefully and make sure you understand the instructions before using the machine. See instructions under the heading ”Personal protective equipment”. Explanation of warning levels The warnings are graded in three levels. WARNING! ! WARNING! [. . . ] Once the machine is running, a detector reads the fuel quality which takes about ten seconds. If the correct amount of Husqvarna OilGuard oil has been used, the machine will run at a normal speed. If the wrong type of oil has been used, the machine senses this and restricts the speed of the engine to 3, 800 rpm to avoid damaging the engine. In order for the machine to run at normal speed again, you must drain the incorrect fuel mixture and then fill the machine with a fuel mixture containing the correct ratio (2 %) of Husqvarna OilGuard oil. • English – 13 OPERATING Protective equipment General • Do not use the machine unless you are able to call for help in the event of an accident. • Keep in mind that it is you, the operator that is responsible for not exposing people or their property to accidents or hazards. Signs and stickers must be fully legible. • Personal protective equipment You must use approved personal protective equipment whenever you use the machine. Personal protective equipment cannot eliminate the risk of injury but it will reduce the degree of injury if an accident does happen. The use of products such as cutters, grinders, drills, that sand or form material can generate dust and vapours which may contain hazardous chemicals. Check the nature of the material you intend to process and use an appropriate breathing mask. Long-term exposure to noise can result in permanent hearing impairment. Listen out for warning signals or shouts when you are wearing hearing protection. Always wear: • • • • • • • Approved protective helmet Hearing protection Protective goggles or a visor Breathing mask Heavy-duty, firm grip gloves. Tight-fitting, heavy-duty and comfortable clothing that permits full freedom of movement. Boots with steel toe-caps and non-slip sole. Always use common sense It is not possible to cover every conceivable situation you can face. If you get into a situation where you feel unsafe, stop and seek expert advice. The machine can be a dangerous tool if used incorrectly or carelessly, which can cause serious or fatal injury to the operator or others. Never allow children or other persons not trained in the use of the machine to use or service it. Never allow anyone else to use the machine without first ensuring that they have understood the contents of the operator’s manual. Never use the machine if you are fatigued, while under the influence of alcohol or drugs, medication or anything that could affect your vision, alertness, coordination or judgement. ! ! ! WARNING!Unauthorized modifications and/ or accessories may lead to serious injury or death to the user or others. Under no circumstances may the design of the machine be modified without the permission of the manufacturer. Do not modify this product or use it if it appears to have been modified by others. [. . . ] Tighten the fastening well and ensure that the free end is as short as possible. Secure the end of the starter cord in the starter handle. • Remove the recoil spring by turning the starter over and loosen the hooks, with the help of a screwdriver. The hooks hold the return spring assembly on the starter. Tensioning the recoil spring • Guide the cord through the cut-out in the periphery of the pulley and wind the cord 3 times clockwise around the centre of the starter pulley. • Lubricate the recoil spring with light oil. Fit the pulley and tension the recoil spring. Fitting the starter • To fit the starter, first pull out the starter cord and place the starter in position against the crankcase. [. . . ]