User manual HUSQVARNA MASTER GARDEN

[. . . ] Release the Operator Presence control to stop the engine before pushing the mower across surfaces other than grass and when transporting the lawnmower to and from the area to be mowed. Never operate the lawnmower with damaged guards or without guards in place. Read the user instructions carefully to make sure you understand all the controls and what they do. Tilting or lifting the lawnmower may cause stones to be thrown out Keep bystanders away. [. . . ] Release the Operator Presence Control, to stop the engine, wait until the blade has stopped and disconnect the spark plug lead and wait until the engine has cooled:before refuelling; before clearing a blockage; before checking, cleaning or working on the appliance; if you hit an object. Do not use your lawnmower until you are sure that the entire lawnmower is in a safe operating condition; if the lawnmower starts to vibrate abnormally. Keep all nuts, bolts and screws tight to be sure the lawnmower is in safe working condition. Only use the replacement blade, blade bolt, spacer and impeller specified for this product. Never store the lawnmower with fuel in the tank inside a building where fumes can reach an open flame or spark. To reduce fire hazard, keep the engine, silencer, battery compartment and fuel storage area free of grass, leaves or excessive grease. Be careful during adjustment of the machine to prevent entrapment of the fingers between moving blades and fixed parts of the machine. Fit the lower handle ensuring that the formed ends are located properly in corresponding slots either side of the lawnmower. In the packaging you will find 2 stops one marked -H- and one marked -V-. To lock the handlebar in a fixed position, attach the stops as shown in the illustration (E). You must release the brake by pulling the OPC lever to the handle before pulling out the cord. USE GLOVES Renew your metal blade after 50 hours mowing or 2 years whichever is the sooner - regardless of condition. When reassembling the blade ensure that the retaining washer is flat and not dished, tighten the bolt to a torque of 35-40 Nm. Remove the blade to gain access to the oil drain plug, open the drain plug underneath the mower and let the oil run out. The engine brake cable should always be adjusted to stop the engine within 3 sec. Transport Remove the spark plug lead Loosen the wire/cable from the handle before carefully folding it. The machine must be drained of oil and fuel when moving it by public transport. Service When ordering spare parts, always quote the mower's product number. Ask your local Service Centre to clean the air filter thoroughly and carry out any service or repairs required. Store in a cool, dry place where your lawnmower is protected from damage. service Recommendations Your product is uniquely identified by a silver and black product rating label. We strongly recommend that your product is serviced at least every twelve months, more often in a professional application. [. . . ] Once petrol has been replaced, it may take a little time for fresh petrol to filter through. If the engine still lacks power and/or is overheating, immediately disconnect the spark plug lead. If vibration persists, turn the blade through 1800 by first loosening the blade bolt, turning the blade and re-tightening the blade bolt. ENVIRONMENTAL INFORMATION Husqvarna Outdoor Products are manufactured under an Environmental Management System (ISO 14001) using, where practical, components manufactured in the most environmentally responsible manner, according to company procedures, and with the potential for recycling at the end of the products' life. [. . . ]