User manual HUSQVARNA R147S AUTOSTART

[. . . ] Assemble the handle fit the levers with the pins and clips provided, assemble the wheels as shown and throttle if supplied. Touch-N-Mow Remove the bail arms, attach cables as shown and re-fit the bail arms, if applicable. Assemble the handle fit the levers with the pins and clips provided, assemble the wheels as shown and throttle if supplied. To cut the grass with the mulching system (no grass collection), lift the rear deflector panel and insert the cap by fixing it with the spring as shown in the figure. [. . . ] Act on the safety lever (14) ) and keep it pressed against the handgrip. Push the Touch-N-Mow start lever (16) forward and check the motor start up. Caution: if the motor does not start, it means that the Touch-N-Mow start up system has been unloaded. Important: Should the motor stop due to lack of gasoline, excessively high grass, or any reason other than the normal stop procedures, the Touch-N-Mow start up system will not reload and it will be necessary to repeat the previously described operations in order to load the system. Prior to any cleaning or transport operation, the start up system shall be unloaded. for this operation , proceed as follows: - Disconnect the spark plug cable. - Act on the safety lever (14) ) and keep it pressed against the handgrip. - The motor will run but it will not start as the spark plug cable is disconnected. Important: If, when you press the clutch lever, the automatic advance gear does not engage, the clutch cable should be adjusted by inserting the spring (P) in one of the subsequent holes in the plate (R) (or in the hole "S" . Periodically check the automatic advance assembly and make sure to keep it clean. In particular, the pinion (20) and the gear (21) must be kept perfectly clean. To carry out this check, you must remove the wheel (22) by unscrewing the screw (23). A)Persons under 16 years of age and persons who are not familiar with the user instructions must not use the lawn mower. B)The operator is responsible for the safety of other people in the working area. Keep children and domestic animals at a safe distance when the lawn mower is in use. , for flattening out bumps in the ground, such as mole-hills or ant- hills). E)Before mowing, remove all foreign objects from the lawn which may be thrown by the machine. While mowing, stay alert for any foreign objects which may have been missed. L If the petrol has overflowed, do not under any circumstances start up the engine. Move the mower away from the area where fuel has bean spilt and avoid any source of possible ignition until the petrol fumes have dissipated. [. . . ] C)Turn off the engine, wait until the blade has stopped and remove the spark plug cap before: l transporting, lifting or moving the machine away from the working area; l carrying out maintenance or cleaning, or when carrying out any operation on the blade; l adjusting the cutting height; l leaving the machine unattended. the fuel is highly inflammable: lStore fuel in containers specifically designed for this purpose. Under no circumstances open the fuel tank cap or add petrol when the engine is running or when it is still hot. Switch off the motor and disconnect the spark plug before undertaking any maintenance work. [. . . ]