User manual HUSQVARNA R50SE

[. . . ] Do not attempt to charge other products with the charger from this unit. Charging should only be carried out in a safe location where neither battery nor cord cable can be trodden on or tripped over. Ensure that neither the charger nor the battery are exposed to moisture. Make sure the lawn is clear of sticks, stones, bones, wire and debris; they could be thrown by the blade. [. . . ] Change the oil after the first five hours operation and thereafter every 25 working hours. Always change the oil while the engine is warm - but not hot - never attempt any maintenance on a hot engine. To avoid introducing dirt into the fuel system, wipe all grass and dirt from the petrol filler cap before unscrewing it. It is recommended that you fill the tank through a funnel with a filter. Please Note :- move the product away from the fuelling area before starting Please Note:- When starting the engine for the first time, fill with oil and petrol as described above in the Oil and Petrol section. Advance engine speed control to FAST `+' as illustrated in the Use - starting and stopping section. Push primer bulb (F) firmly five times Follow instructions in the Use - starting and stopping section. If engine fails to start after three pulls of the pull cord, push primer bulb three times and repeat step 3. Move engine speed control to FAST `+' position and push primer bulb firmly three times before starting engine. (if engine stopped because it ran out of fuel, refuel engine - push primer bulb three times. Move the Engine Speed Control to the FAST `+' position before starting. Pull the operator presence control (OPC) to release the brake on the engine and the blade. Pull the recoil starter fully towards you until you feel the full resistance, return the handle slowly then pull the handle firmly towards you to its full extent. After the engine has started, allow to run for 30 seconds before commencing to use. Forward drive is engaged and disengaged with the Powerdrive lever at the top of the handle (G4). If the engine fails to start when you turn the key your battery may need charging. J1 - drive speed control Engaging the Drive - See R 50S Drive speed can be altered with the drive speed control. (J) Stopping See R 50S Please note:- Your R 50SE can be started manually by following steps 1-5 in Starting & Stopping R 50S Key Start Only - During mowing, your engine will recharge the battery Starting & Stopping R 50S/BBC (BBC - Blade, Brake , Clutch) 1. While holding the BBC arm, push forward BBC control lever until a click is heard (K2). Release the BBC control lever which will return to its original position. Please Note: Leaving the engine running without the blade rotating for an extended length of time could lead to the engine overheating. Engaging the Drive - See R 50S Drive speed can be altered with the drive speed control. [. . . ] Clean the engine air filter (Ask your local Approved Service Centre to clean the engine air filter thoroughly). Once petrol has been replaced, it may take a little time for fresh petrol to filter through. If the engine still lacks power and/or is overheating, immediately disconnect the spark plug lead. Batteriet skall lämnas in till en godkänd servicedepå eller till Din lokala återvinningsstation. [. . . ]