User manual HUSQVARNA TS 1000 F

[. . . ] The user advice and spare parts mentioned in this document are given as an indication, and do not constitute an undertaking. No warrantee will be granted in the event of errors or omissions, or for damage occur-ring during delivery, or caused by the design or use of the machine. We are very concerned about the quality of our products and we reserve the right to make any technical modifications to improve them, without warning. [. . . ] Use only discs marked with a maximum operating speed greater than that of the disk shaft Should the machine wear out or break, it must be disposed of in compliance with legislation in force. Since the motor is often operated in inclined position, check frequently, in horizontal position, that oil level never falls below the second mark on the gauge. Utilization: sawing marble, stone, granite, brick, cement and any covering material such as sandstone, earthenware, ceramics, etc. It is strictly forbidden to use the saw for any purpose other than that for which it has been designed. Make sure that the bearing surfaces of the disk, flanges and shaft are clean. For transport, lock the head as follows: · ⷠPosition the cutting head at the level for locking the transport screws (A) Using wrench (B), tighten the screws (A) until the casters are no longer n contact with the guide bars [FIG. Put back the tightening flange (C), Tighten nut (E), Put back and fasten disk cover Reconnect the water supply tube (F). For your safety and that of others, make sure that all guards are back in place before using. Always remain attentive Danger : risk of cuts To start using the machine, follow the transport procedure in reverse order. Before handling the cut material in any way, stop the motor and wait for the disc to come to a full stop. Sound level at the workstation may exceed 85db (A) and therefore personal protection equipment must be worn. The machine is delivered with an uninstalled head advancement wheel (6) [FIG. 4] For start-up and after transport, the machine must be unbridled: · Loosen screws (A) until casters are in contact with the guide bars [FIG. Heat engine machines may not be operated in a confined space unless there is sufficient ventilation. Place the material on table (2) according to desired cut, using cutting guide (18) and rulers [FIG. For heat engine machines: Start motor according to manufacturer's instruction manual. [. . . ] In this case, please attach the bill of sale, as well as a report describing the problem encountered and asking that it be fixed under the terms of the guarantee. A technical diagnostic will be performed without delay on reception of the machine and you will be sent our conclusions. WARRANTY CONDITIONS To benefit the warranty, it is necessary to return the joined warranty certificate, duly completed, to Husqvarna within eight days of the purchase. [. . . ]