User manual HUSQVARNA TS 230 F

[. . . ] By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. For more detailed information about recycling of this product, please contact your local council office, your household waste disposal service or the shop where you purchased the product. [. . . ] It should be read and used by any person installing or using the machine. The obligatory technical regulations in force in the country where the machine is used must also be adhered to for maximum safety. This symbol indicates that the machine is in conformance with the applicable European directive. Before use, read the instructions carefully and familiarise yourself with the machine. The working area must be perfectly tidy, well lit and must offer no risks (no humidity or dangerous products in the vicinity). These signs give advice concerning your safety The operator must wear suitable protection when working. Use blades suitable for the work to be done (speed, geometry, application, etc. Make sure the contact faces of flanges, of blade and the axle are clean Cutting width (Lg) with guide at 90° : 305 mm to the left 147 mm to the right · length of cut unlimited. 4 Electrical connections - ELECTRICAL SAFETY : Operate this machine only on a supply equipped with a 30 mA earthed current-limiting circuit-breaker. For tools supplied with an integral RCCB in the cable or in the mains plug, if the cable or plug has been damaged, repairs must be carried out by the manufacturer, one of his agents or by a qualified repair workshop to avoid any risks resulting from errors. Remove all adjustment tools and wrenches from floor and machine Keep the protective covers in place while the machine is operating. During cutting, place the blade guard as close as possible to the tile, in order to avoid water splash. For rapid delivery of spares and in order to avoid any wasted time, it is necessary to remind your supplier of the details shown on the instruction plate on the machine with each order, as well as the reference of the part to be replaced. - Position the cutting guide - Lower the two clips - Slacken off the two nuts (fig 5). [. . . ] As an alternative, you may return, at your cost, the machine together with a written description of the problem and damages with a copy of the invoice directly to our after sales department where upon a full investigation will be instigated without delay. 4, EXCLUSIONS Warranty will not be applied for damages or failures caused by : - incorrect use, error in transportation, handling or maintenance, - use of incorrect fuel or lubricants not advised by Husqvarna, - use of non-genuine parts or accessories, - repairs made by non approved service centres, - use of incorrect specifications of cutting tools. [. . . ]