User manual HUSQVARNA UTILITY VEHICLE

[. . . ] 2007 Utility Vehicles Gasoline and Diesel Owner’s Manual HUV 4421G HUV 4421GXP HUV 4421D HUV 4421DXP NOTICE Warranty information appears on the last pages of this manual. Your authorized representative checked the vehicle before it was delivered to you and will provide you a copy of the completed vehicle warranty registration form. Husqvarna is not liable for errors in this manual or for incidental or consequential damages that result from the use of the material in this manual. This manual contains proprietary information that is protected by copyright. [. . . ] If the battery is dead, see Using A Booster Battery (Jump Starting) on page 46. Make sure the key switch is in the OFF position and the Forward/Reverse handle is in the NEUTRAL position. Following the manufacturer’s directions, add a commercially available fuel stabilizer (such as StaBil®). Run the engine in a well-ventilated area to allow treated fuel to replace untreated fuel in the carburetor. Disconnect the fuel vent line from the fuel tank vent nipple (Figure 35, Page 43). Remove both spark plugs, and pour 1/2 ounce (14. 2 mL) of SAE 10 weight oil through each of the two spark plug holes. Rotate the engine crankshaft by hand several times, then install both spark plugs. Diesel vehicles: If Biodiesel fuel is used, see Biodiesel Fuel (Diesel Vehicles Only) on page 43. Disconnect the fuel vent line from the fuel tank vent nipple (Figure 36, Page 43). See WARNING “To avoid unintentionally starting. . . ” on page 9. 2007 HUV 4421 Gasoline and Diesel Vehicle Owner’s Manual Page 27 Maintenance 9. Wash the battery top and terminals with a solution of baking soda and water (1 cup (237 mL) baking soda per 1 gallon (3. 8 L) of water). Let the terminals dry and then coat them with Battery Terminal Protector Spray (P/N 603 00 00-03). Thoroughly clean the front body, rear body, seats, cargo bed, engine compartment, and underside of vehicle. Chock the wheels to prevent the vehicle from rolling. RETURNING THE STORED VEHICLE TO SERVICE 1. Make sure the key switch is in the OFF position and the Forward/Reverse handle is in the NEUTRAL position. Restore the fuel system to operation (Figure 35 or Figure 36, Page 43). Connect the battery cables, positive (+) cable first, and tighten the terminals to 12 ft-lb (16 N·m). Coat terminals with Battery Terminal Protector Spray (P/N 603 00 00-03). Gasoline vehicles only: Completely open the fuel shut-off valve (Figure 13, Page 27). A partially closed fuel shut-off valve combined with the use of the choke can result in a fouled spark plug and engine failure (Figure 14, Page 27). Crank the engine until fuel is pumped into the carburetor (gasoline vehicles) and the fuel lines (all vehicles) and the engine starts. [. . . ] (3) Any warranted part that is scheduled for replacement as required maintenance in the written instructions supplied is warranted for the period of time before the first scheduled replacement date for that part. If the part fails before the first scheduled replacement, the part will be repaired or replaced by CLUB CAR according to subsection (4) below. Any such part repaired or replaced under warranty will be warranted for the remainder of the period prior to the first scheduled replacement point for the part. (4) Repair or replacement of any warranted part under the warranty provisions herein must be performed at a warranty station* at no charge to the owner. [. . . ]