User manual IMATION DEFENDER F100

[. . . ] The device uses pre-installed ACCESS Standard software to guide you through the personalization process. ACCESS Standard starts automatically when you plug in a new (or recycled) device. If autorun is not configured for your computer, you can start ACCESS Standard from the application partition on the device. [. . . ] Note 2: After you successfully complete the Personalization process, you can access your private partition using a file manager. For more information about logging in and saving files to or opening files from the private partition, see "Accessing data on the device" on page 7. 6 ACCESSING DATA ON THE DEVICE After you personalize a device, only registered users can authenticate to it. After you successfully log in, you can save files to, and open files from, your private partition. It is recommended that you log out of your device if you must leave it connected while you are away from your computer. Otherwise, another user could access your private partition while you are absent. You can also disconnect the device completely to bring the data with you. This chapter provides information about the following topics: · Logging into and out of the device · Saving and opening files · Disconnecting the device LOGGING INTO AND OUT OF THE DEVICE To log into the device 1. From the notification area, at the far right of the taskbar, right-click the Defender icon and click Login. If you are using a computer running Mac OS X, open a file manager and click the application drive for the device. On the main page of ACCESS Standard, under Manage Device, click Login. Follow the prompts in the authentication wizard until the device successfully authenticates you. To log out of the device 1. From the notification area, at the far right of the taskbar, right-click the Defender icon and click Logout. If you are using a computer running Mac OS X, open a file manager and click the application drive for the device. On the main page of ACCESS Standard, under Manage Device, click Logout. Tip: You can also log out of your device by right-clicking the Defender icon, and then clicking Eject Device. For more information, see "Disconnecting the device" on page 8. SAVING AND OPENING FILES When you plug in your device both the application drive and the private partition display in a file manager, such as Windows® Explorer, with an associated drive letter for each partition. Application drive Private partition 7 ACCESSING DATA ON THE DEVICE cont. Once you log into the device, you can open files on your private partition using the appropriate program or a file manager. When you save data to your private partition, the device encrypts the data using hardware-based AES 256-bit encryption. Note: You cannot save data to or delete data from the application partition. DISCONNECTING THE DEVICE To disconnect the device · From the notification area at the far right of the taskbar, right-click the Defender icon and click Eject Device. If you are using a computer running Mac OS X, drag the device drive on the desktop to the Trash. Tip: You can also disconnect the device by clicking the Safely Remove Hardware icon in the notification area at the far right of the taskbar. [. . . ] Some jurisdictions do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you. This warranty gives you specific rights you may have other rights that vary from country to country. Regulatory Compliance: FCC This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Residential use statement: NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. [. . . ]