User manual INDESIT BAN12NFS

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual INDESIT BAN12NFS. We hope that this INDESIT BAN12NFS user guide will be useful to you.


INDESIT BAN12NFS : Download the complete user guide (443 Ko)

Manual abstract: user guide INDESIT BAN12NFS

Detailed instructions for use are in the User's Guide.

[. . . ] In order to maintain the correct distance between the appliance and the wall behind it, fit the spacers supplied in the installation kit, following the instructions provided. Changing the plug: Removing the plug If your appliance has a non-rewireable moulded plug and you should wish to remove it to add a longer cable or to re-route the mains cable through partitions, units etc. please ensure that either: - The plug is replaced by a fused 13amp rewireable plug bearing the BSI mark of approval. or - The mains cable is wired directly into a 13amp cable outlet, controlled by a switch (in compliance with BS 5733) which is accessible without moving the appliance. Disposing of the plug Cut off and dispose of the supplied plug if it does not fit your socket. [. . . ] The appliance comes with a motor protection control system which makes the compressor start approximately 8 minutes after being switched on. The compressor also starts each time the power supply is cut off whether voluntarily or involuntarily (blackout). Insert the plug into the socket and ensure that the internal light illuminates ( the FREEZER OPERATION knob must not be on the position) . Turn the FREEZER OPERATION knob and REFRIGERATOR OPERATION knob to an average value. After a few hours you will be able to put food in the refrigerator. Using the refrigerator to its full potential · Place only cold or lukewarm foods in the compartment, not hot foods (see Precautions and tips). · Remember that cooked foods do not last longer than raw foods. They will increase humidity in the refrigerator and cause condensation to form. Setting the temperature The temperature inside the refrigerator compartment automatically adjusts itself according to the position of the thermostat knob. min= warmest max = coldest We recommend, however, a medium position. Chiller system No Frost It is recognisable by aeration cells located on the back walls of the compartments. The No Frost system circulates cold air continuously to collect humidity and prevent ice and frost formation. The system maintains an optimal humidity level in the compartment, preserving the original quality of the food, preventing the food from sticking together and making defrosting a thing of the past. Do not block the aeration cells by placing food or containers in direct contact with the refrigerating back panel. Close bottles and wrap food tightly. 6 Using the freezer to its full potential The temperature inside the freezer compartment automatically adjusts itself according to the position of the thermostat knob. switches the appliance off, including the refrigerator. Ice3 ice tray The fact that they are situated on the top part of the freezer drawers ensures greater cleanliness: the ice no longer comes into contact with the food placed inside the freezer compartment; furthermore, the dripping of the water during filling is avoided (a lid to cover up the hole after filling with water is also provided). 1. Check that the tray is ompletely empty and fill it with water through the opening provided. Excess water prevents the ice cubes from dispensing (if this happens, wait for the ice to melt and empty the tray). Turn the tray 90°: due to the connected compartments each mould fills with water (see diagram). Close the opening with the lid provided and put the tray back, placing the top part in the corresponding housing and allowing it to drop in again. When the ice has formed (minimum time approximately 8 hours) knock the tray against a hard surface and wet the outside so that the ice cubes come loose and take them out through the opening. GB · Do not re-freeze food that is defrosting or that has already been defrosted. · Fresh food that needs to be frozen must not come into contact with food that has already been defrosted. Fresh food must be stored in the top FREEZER and STORAGE compartment where the temperature drops below -18°C and guarantees rapid freezing. · If you want to switch the appliance off for an extended period of time, clean the inside and leave the doors open. 8 Precautions and tips !The appliance was designed and manufactured in compliance with international safety standards. [. . . ] The TEMPERATURE ADJUSTMENT knob is not in the correct position The refrigerator or the freezer have been over-filled. The food inside the refrigerator is beginning to freeze. The appliance makes a lot of noise. · The TEMPERATURE ADJUSTMENT knob is not in the correct position. · The door is not closed properly or is continuously opened. · The appliance has not been installed on a level surface (see Installation). · The appliance has been installed between cabinets that vibrate and make noise. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE INDESIT BAN12NFS




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual INDESIT BAN12NFS will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.