User manual INDESIT DP2GS

[. . . ] For specific instructions, kindly read the part reserved for the installation technician. The ignition of the gas burner is carried out by putting a small flame to the upper part holes of the burner, pressing and rotating the corresponding knob in an anti-klockwise manner, until the maximum position has coincided with the marker. When the gas burner has been turned on, adjust the flame according to need. The minimum position is found at the end of the anticlockwise rotation direction. [. . . ] The minimum position is found at the end of the anticlockwise rotation direction. In models with automatic ignition, operate the knob as described above, pressing simultaneously, the corresponding push button. For models with automatic/ simultaneous (with one hand) ignition, it is sufficient to proceed as described above using the corresponding knob. The electric spark between the ignition plug and the burner provides the ignition of the burner itself. After ignition, immediately release the push-button and adjust the flame according to need. For models with a thermoelectric safety system, the burner is ignited as in the various cases described above, keeping the knob fully pressed on the maximum position for approximately 3/5 seconds. : - we recommend the use of pots and pans with a diameter matching that of the burner, thus preventing the flame from escaping from the bottom part and surrounding the pot - do not leave any empty pots or pans on the fire - do not use any tools for grill-cooking on Crystal hobs. When cooking is finished, it is also a good norm to close the main gas pipe tap and/ or cylinder. 1 wok fast auxiliary Ø 20-32 Ø 20-26 Ø 10-14 Prior to any operation, disconnect the appliance from the electrical system. For long-life to the equipment, a general cleaning operation must take place periodically, bearing in mind the following: - the glass, steel and/or enamelled parts must be cleaned with suitable non-abrasive or corrosive products (found on the market). If connecting directly to the mains power supply, fit a multi-pole switch of a suitable size for the rated capacity with a clearance distance which completely disconnects the power line under overvoltage category III conditions, consistently with the rules of installation (the yellow/green earth wir must not be interrupted). The plug or omnipolar switch must be easily reached on the installed equipment. 3) Connect the appliance to the gas cylinder or to the installation according to the prescribed standards in force, and ensure beforehand, that the appliance matches the type of gas available. The type of gas for which the appliance is predisposed is shown on the appliance identification plate. Furthermore, check that the feed pressure falls within the values described on the table: “User chacteristics”. Rigid/semi rigid metal connection Carry out the connection with fittings and metal pipes (even flexible pipes) so as to obtain counter stress the inner parts of the appliance. - when the installation has been carried out, check the perfect sealing of the entire connection system, by using a soapy solution. 4 12 To avoid all risk, if the power cable becomes damaged, it must only be replaced by the manufacturer, by an authorised service centre, or by a qualified electrician. Wok C3 only GB Should the appliance be pre-set for a different type of gas than that available, proceed as follows: • replace the injectors (Fig. 5) with the corresponding type of gas to be used (see table “Uses characteristics”). [. . . ] Wok C3 only GB Should the appliance be pre-set for a different type of gas than that available, proceed as follows: • replace the injectors (Fig. 5) with the corresponding type of gas to be used (see table “Uses characteristics”). € to adjust to the minimum, use a screwdriver on the screw placed on the tap (Fig. For LPG (butane/propane) screw tight Adaptation to various types of gas (Fig. [. . . ]