User manual INDESIT IDC75
DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual INDESIT IDC75. We hope that this INDESIT IDC75 user guide will be useful to you.
Manual abstract: user guide INDESIT IDC75
Detailed instructions for use are in the User's Guide.
[. . . ] If you have any doubts, do not use the appliance, contact your nearest Ariston Service Centre. Never leave the packing components (plastic bags, foamed polystyrene, nails, etc. ) within the reach of children since they are a source of potential danger. 4 The appliance must be installed only by a qualified person in compliance with the instructions provided. The manufacturer declines all responsibility for improper installation which may harm persons and animals and damage property. 5 The electrical safety of this appliance can only be guaranteed if the cooker is correctly and efficiently earthed, in compliance with current regulations on electrical safety. [. . . ] It is important to make sure the safety chain is always situated on the side which corresponds to the hose holder (Fig. without hood
Mounting the legs (only on a few models) Press-fit legs are supplied which fit under the base of your cooker.
Fig. B Gas connection The cooker should be connected to the gas-supply by a corgi registered installer. During installation of this product it is essential to fit an approved gas tap to isolate the supply from the appliance for the convenience of any subsequent removal or servicing. Connection of the appliance to the gas mains or liquid gas must be carried out according to the prescribed regulation in force, and only after it is ascertained that it is adaptable to the type of gas to be used. If not, follow the instructions indicated in the paragraph headed "Adaptation to different gas types". On some models the gas supply can be connected on the left or on the right, as necessary; to change the connection, reverse the position of the hose holder with that of the cap and replace the gasket (supplied with the appliance). In the case of connection to liquid gas, by tank, use pressure regulators that conform to the regulation in force. The gas 4
supply must be connected to the left of the appliance. Be sure that the hose does not pass through the rear of the cooker touching hot parts.
colour as indicated by the coloured marking or the colour that is embossed in words on the base of the plug. Replacements can be obtained directly from your nearest Service Depot. D b) Minimum regulation of the gas oven burner with thermostat (see fig. ): · light the burner as described in the paragraph "the oven knob" of the instruction booklet. · turn the knob to Max for about 10 minutes and then turn the knob to the Min setting; · remove the knob; · regulate the screw positioned outside the thermostat pin until the flame is small but steady. N. B. : in the case of liquid gas, the regulation screw must be screwed in to the bottom.
check that the burner does not turn off when you turn the knob from Max to Min and and when you open and close the oven door quickly.
Adapting the gas grill to different types of gas Replacing the nozzle of the grill burner: · remove the screw and then slide out the grill burner "V" (see Fig. E); · unscrew the grill burner nozzle using the special socket spanner for the nozzles (see Fig. F) or better still a 7 mm socket spanner; replace the nozzle with a nozzle for the new type of gas (see table 1).
Fig. F Important: when mounting the grill burner check that there is a space of at least 4 mm between the security thermocouple (if installed) and the burner.
Important On completion of the operation, replace the old rating sticker with one indicating the new type of gas used. Note Should the pressure of the gas used be different (or vary) from the recommended pressure, it is necessary to fit a suitable pressure regulator onto the inlet pipe in compliance with current National Regulations relative to "regulators for channelled gas".
Burner and nozzle characteristics
Table 1 Burner Diameter (mm) Thermal Power kW (p. c. s. *) Nominal Fast (Large)(R) Semi Fast (Medium)(S) Auxiliary (Small)(A) Triple Crown (TC) Oven Grill Supply Pressures 100 75 55 130 3. 00 1. 90 1. 00 3. 25 3. 02 2. 50 Nominal (mbar) Minimum (mbar) Maximum (mbar) Reduced 0. 7 0. 4 0. 4 1. 5 1. 0 By-Pass 1/100 (mm) 41 30 30 63 49 Liquid Gas Nozzle 1/100 (mm) 86 70 50 91 85 80 *** 218 138 73 236 219 182 28-30 20 35 Flow* g/h ** 214 136 71 232 216 179 37 25 45 Natural Gas Nozzle 1/100 (mm) 116 106 79 133 132 122 20 17 25 286 181 95 309 288 227 Flow* l/h
* ** ***
At 15°C and 1013 mbar- dry gas Propane P. C. S. = 37, 78 MJ/m3
K 642 G/G K 642 GS/G
K 647 GS/G
Mains frequency and voltage of the electric section and characteristics of the gas section Model Class K 642 G/G K 642 GS/G K 647 GS/G Gas section Rated power kW (1) 10, 82 (787 g/h - G30) (773 g/h - G31) 12, 17 (885 g/h - G30) (869 g/h - G31) Electric section Voltage
(1) The values in g/h refer to the capacities with liquid gas (Butane, Propane).
Inner dimensions of the oven: Width: 40. 7 cm Depth: 40 cm Height: 34 cm Inner Volume of the Oven: 55 lt Innder dimensions of the plate plate warmer: Width: 43 cm Depth: 43 cm Height: 8 cm Voltage and Frequency of Power Supply: see data plate Burners: adaptable for use with all the types of gas indicated on the data plate This appliance conforms with the following European Economic Community directives: 73/23/EEC of 19/02/73 (Low Voltage) and subsequent modifications; 89/336/EEC of 03/05/89 (Electromagnetic Compatibility) and subsequent modifications; 90/396/EEC of 29/06/90 (Gas) and subsequent modifications; 93/68/EEC of 22/07/93 and subsequent modifications.
The cooker with gas oven
E D K
A B C D E F G Tray for Catching Overflows Gas Burner Instantaneous Electronic Lighting Device Top Grate Control Panel Adjustable Feet or Legs Dripping Pan or Baking Sheet H Flame Failure Device for Cooktop Burners (only a few models) K Oven Rack L Electronic Lighting for Hob Burners M Oven Control Knob N Control Knobs for Gas Burners on Hob O Button for Oven and Rotisserie Light P Timer Knob
The different functions and uses of the oven
The various functions included in the cooker are selected by operating the control devices located on the cooker control panel. Control Knobs for the Gas Burners on the Hob The position of the gas burner controlled by each one of the knobs is shown by a symbol of a solid ring:·. To light one of the burners, hold a lighted match or lighter near the burner. Press down and turn the corresponding knob in the counter-clockwise direction to the maximum setting. [. . . ] (For the models provided with electronic lighting see the relative paragraph). The cooking temperature is selected by matching the desired temperature with the permanent reference on the panel; the complete range of temperatures is shown below:
Oven light button (O) This is marked by the symbol and switchs on the light inside the oven so that you can control the cooking without opening the door. Timer Knob To use the timer, the ringer "S" must be wound up by turning the knob one full turn clockwise ; then turn it back , to the desired time so that the number of minutes on the knob matches the reference mark on the panel. Attention Avoid the children touch the oven door because it is very hot during the cooking. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE INDESIT IDC75
Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual INDESIT IDC75 will begin.