User manual INDESIT IS60G1W

[. . . ] € Disconnect the plug from the mains before cleaning or maintenance of the vacuum cleaner. All servicing and repairs must be carried out by an authorised Electrolux service centre. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similary qualified person in order to avoid a hazard. 3* 4* Teleskoprør Støvsugerrør Slangehåndtak + slange Munnstykke for teppe / hardt gulv Dust Magnet, kombinert munnstykke for tepper og harde gulv 5. [. . . ] 12 Attach the extension tube* or telescopic tube* to the hose handle and nozzle by pushing and twisting together. 15 ON/OFF control: Push the ON-OFF button once to start the vacuum cleaner. 16 Power Regulation: Twist the power control towards „max” to increase the suction power. Twist the power control towards „min” to decrease suction power. Additional suction power control: Use the suction control on the hose handle. 17 Practical parking positions (and at the same time a backsaving feature) when you pause during cleaning or when you carry and store the vacuum cleaner. 18 You can also carry the vacuum cleaner using the handle on top or on the lower front edge of the machine. 19 Keep the hose in place while storing the vacuum cleaner by extending the elastic bumper cord and placing it across the hose. Use the nozzles as follows: Carpets: 20 Accessories on board 3 in 1 multi tool nozzle to be found in the back of the cleaner. Hårda golv: * Use the carpet/hard floor nozzle with lever in position (21). * On the Dust Magnet nozzle (23 and 24) there is normally no need to switch mode. Replacement of the exhaust filter 30 31 The filters must always be replaced with new ones and cannot be washed (if not mentioned). 32 Place your thumbs on the back edge of the lid and then open the lid by pulling the handle backwards and upwards with your index/middle finger. Rinse the inside (dirty side) of the filter unit under warm tap water only. Do not use cleaning agents and avoid touching the delicate filter surface. Replace the unit back into the cleaner and close cover ensuring it is properly fastened. English Cleaning the hose and nozzle The vacuum cleaner stops automatically if the nozzle, tube, hose or filters and s-bag® becomes blocked. In such cases, disconnect from mains and allow to cool for 20-30 minutes. 36 It may also be possible to remove the obstruction in the hose by squeezing it. However, be careful in case the obstruction is caused by glass or needles caught inside the hose. Note: The warranty does not cover any damage to the hose caused by cleaning it. 37 To avoid deterioration of suction power, frequently clean the carpet/ hard floor nozzle. [. . . ] Water has entered the vacuum cleaner It will be necessary to replace the motor at an authorised Electrolux service centre. Damage to the motor caused by the penetration of water is not covered by the warranty. Com Consumer information Electrolux decline all responsibility for all damages arising from any improper use of the appliance or in cases of tampering with the appliance. Børsteindstillingen bør bruges for at opnå den bedste støvfjernelse selv på vanskelige hårde gulve eller for at opnå en børsteeffekt på gulvtæpper. [. . . ]