User manual INDESIT IWD6125E

[. . . ] Read these instructions carefully: they contain vital information relating to the safe installation and operation of the appliance. Connecting the electricity and water supplies Connecting the water inlet hose Unpacking and levelling Unpacking 1. Make sure that the washing machine has not been damaged during the transportation process. If it has been damaged, contact the retailer and do not proceed any further with the installation process. Remove the 3 protective screws (used during transportation) and the rubber washer with the corresponding spacer, located on the rear part of the appliance (see figure). 1. [. . . ] To open the door during a running wash cycle, press the START/PAUSE button; the door may be opened once the DOOR LOCKED indicator light turns off. GB Starting a wash cycle 1. All indicator lights will switch on for a few seconds, then they will switch off and the START/PAUSE indicator light will pulse. Measure out the detergent and washing additives (see “Detergents and laundry”). Start the wash cycle by pressing the START/PAUSE button and the corresponding indicator light will remain lit in a fixed manner, in green. To cancel the set wash cycle, pause the machine by pressing the START/PAUSE button and select a new cycle. Take out your laundry and leave the appliance door ajar to make sure the drum dries completely. Switch the washing machine off by pressing the ON/OFF button. 7 Wash cycles GB Table of wash cycles Wash cycles Description of the wash cycle Detergents Max. speed Cycle duration (°C) (rpm) Wash Fabric Normal Eco softener Time 90° 60° 40° 60° 40° 30° 50° 40° 40° 30° 40° 30° 60° 30° 30° 30° 1200 1200 1200 1200 1200 1200 800 800 800 0 800 800 1200 600 600 600 1200 1200 0                                  6 6 6 6 6 6 2, 5 2, 5 1, 5 1 3 1, 5 3, 5 3 3 Max. 2 pairs 6 6 6 3, 25 3, 25 3, 25 2 2 The duration of the wash cycles can be checked on the display. Daily 1 White Cotton: extremely soiled whites. The washing machine will automatically prevent you from selecting a temperature which is higher than the maximum value set for each wash cycle. GB Setting the spin speed Turn the SPIN SPEED knob to set the spin speed for the selected wash cycle. The maximum spin speeds available for each wash cycle are as follows: Wash cycles Maximum spin speed Cottons 1200 rpm Synthetics 800 rpm Wool 800 rpm Silk drain only The spin speed may be lowered, or the spin cycle can be excluded altogether by selecting the symbol . This washing machine was designed and constructed in accordance with international safety regulations. The following information is provided for safety reasons and must therefore be read carefully. Consumers should contact their local authority or retailer for information concerning the correct disposal of their old appliance. GB General safety • This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance. • Do not touch the machine when barefoot or with wet or damp hands or feet. • Do not pull on the power supply cable when unplugging the appliance from the electricity socket. • Do not open the detergent dispenser drawer while the machine is in operation. • Do not touch the drained water as it may reach extremely high temperatures. This could damage the safety lock mechanism designed to prevent accidental opening. • If the appliance breaks down, do not under any circumstances access the internal mechanisms in an attempt to repair it yourself. • Always keep children well away from the appliance while it is operating. [. . . ] • The drain hose is not fixed properly (see “Installation”). • Switch off the machine and unplug it, wait for approximately 1 minute and then switch it back on again. If the problem persists, contact the Technical Assistance Service. The washing machine does not take in water (“H2O” will flash on the display). The washing machine continuously takes in and drains water. The washing machine does not drain or spin. The washing machine vibrates a lot during the spin cycle. The washing machine leaks. The “function” indicator lights and the “start/pause” indicator light flash, while one of the “phase in progress” indicator lights and the “door locked” indicator light will remain lit in a fixed manner. There is too much foam. • The detergent is not suitable for machine washing (it should display the text “for washing machines” or “hand and machine wash”, or the like). [. . . ]