User manual INDESIT IWDE7168

[. . . ] Levelling the machine correctly will provide it with stability, help to avoid vibrations and excessive noise and prevent it from shifting while it is operating. If it is placed on carpet or a rug, adjust the feet in such a way as to allow a sufficient ventilation space underneath the Washer-dryer. Connecting the electricity and water supplies Connecting the water inlet hose Unpacking and levelling Unpacking 1. Make sure that the Washer-dryer has not been damaged during the transportation process. [. . . ] Cupboard dry: suitable for laundry which can be put back in a cupboard without being ironed; "A3" appears on the display. Extra dry: suitable for garments which need to be dried completely, such as sponges and bathrobes "A4"; appears on the display. 8 If your laundry load to be washed and dried is much greater than the maximum stated load (see adjacent table), perform the wash cycle, and when the cycle is complete, divide the garments into groups and put some of them back in the drum. 2 pairs 5 3 0, 5 7 7 7 3, 5 3, 5 2 The duration of the wash cycles can be checked on the display. 7 Jeans - Sport 8 Sport Intensive 9 Sport Light 10 Special Shoes - Dry 11 Cotton 12 Synthetics 13 Express Wash & Dry Partial wash cycles 30° - 1600 1600 1600 0 - Rinse Spin Drain The information contained in the table is intended as a guide only. For all Test Institutes: 1) Test wash cycle in compliance with regulation EN 50229: set wash cycle 1 with a temperature of 60°C. 2) Long wash cycle for cottons: set wash cycle 1 with a temperature of 40°C. 3) Short wash cycle for cottons: set wash cycle 3 with a temperature of 40°C. Wash options Selecting this option enables you to suitably adjust drum rotation, temperature and water to a reduced load of lightly soiled cotton and synthetic fabrics (refer ” enables you to to the "Table of wash cycles"). We suggest using a liquid detergent suitably measured out to the load quantity. Cycles 1, 5, 6, 7, 8, 9, 10, 11, 12, 13, Intensive Wash Because a greater quantity of water is used in the initial phase of the cycle, and because of the increased cycle duration, this function offers a highperformance wash. If, after several attempts, the load is not balanced correctly, the machine spins at a reduced spin speed. If the load is excessively unbalanced, the Washer-dryer performs the distribution process instead of spinning. To encourage improved load distribution and balance, we recommend small and large garments are mixed in the load. Preparing the laundry • Divide the laundry according to: - the type of fabric/the symbol on the label - the colours: separate coloured garments from whites. • Do not exceed the listed values, which refer to the weight of the laundry when dry: Durable fabrics: max. 1 1 1 1 1 sheet 400-500 g pillow case 150-200 g tablecloth 400-500 g bathrobe 900-1200 g towel 150-250 g Special wash cycles Wool: all wool garments can be washed using programme 5, even those carrying the "hand-wash label. For best results, use special only" detergents and do not exceed 1, 5 kg of laundry. We recommend the use of special detergent which has been designed to wash delicate clothes. 10 Precautions and tips  This Washer-dryer was designed and constructed in accordance with international safety regulations. The following information is provided for safety reasons and must therefore be read carefully. • Make sure that the water tap is turned on during the drying cycles. [. . . ] The "option" indicator lights and the • Switch off the machine and unplug it, wait for approximately 1 minute "start/pause" indicator light flash and then switch it back on again. • • • • • The appliance is not plugged into the socket, or not enough to make contact. Service GB Before calling for Assistance: • Check whether you can solve the problem alone (see “Troubleshooting”); • Restart the programme to check whether the problem has been solved; • If this is not the case, contact an authorised Technical Assistance Centre using the telephone number provided on the guarantee certificate. Have the following information to hand: • the type of problem; • the appliance model (Mod. [. . . ]