User manual INDESIT KP59MS

[. . . ] Please read these instructions carefully before using this product, and save this manual for future use. Book 3 ページ ２０１３年１月１６日　水曜日　午前１１時３５分 ENGLISH Before Use • This Marine Case is designed for a Panasonic Digital Camera. € In the case of water leakage due to insufficient care, Panasonic is in no way liable for damage to any products (digital camera, batteries, card etc. • Panasonic also offers no compensation for accidents resulting in injury or damage to property. [. . . ] € Inspect the front case groove as well as the rear case (side where O-ring is set) groove. Book 10 ページ ２０１３年１月１６日　水曜日　午前１１時３５分 4 Apply the grease (supplied). Apply O-ring grease to clean the surface of the O-ring and replenish the oil. € Apply a rice-grain size of grease (supplied) evenly to the O-ring with the tip • • • of your finger. ) If there is too much grease on the O-ring, dirt and dust will stick to it causing water to leak in. Therefore, hold the O-ring between the balls of your finger and thumb and gently remove excess grease. By applying the O-ring grease thinly and evenly, the O-ring fits flexibly to the groove of the marine case and keeps it airtight. The surface of the O-ring may stretch or rip, causing a water leak, when an O-ring grease other than supplied is used, so always use the specified O-ring grease. Check the following: • • • • There is no dirt sticking to the O-ring. cORRECT INCORRECT 10 VQT4V83 (ENG) DMW-MCFT5_PP&E-VQT4V83. Book 11 ページ ２０１３年１月１６日　水曜日　午前１１時３５分 6 Inspect the O-ring one last time. € Silica gel Digital Camera • When inserting the silica gel, bend it as shown in the illustration below and then insert it as far as possible. If you close the Case with the silica gel not fully inserted, the silica gel will get caught in the Oring causing water leakage. Book 15 ページ ２０１３年１月１６日　水曜日　午前１１時３５分 • Check that the buckle is closed firmly. 5 After you have attached the digital camera, check one more time that no water leaks into the Case. (P12) Notes • Be careful not to get the shading hood dirty with fingerprints etc. € Check one more time that the O-ring is fitted evenly into the O-ring groove. Book 17 ページ ２０１３年１月１６日　水曜日　午前１１時３５分 Tips for Taking Pictures in the Water It is recommended to use the Recording Mode (Advanced Underwater) appropriate for underwater when recording underwater. It may not be possible to record images with intended brightness or color depending on the recording conditions (depth/weather/subject), so try using following functions together. Color is reddish, bluish White balance fine adjustment (Advanced Underwater Mode) • This can adjust the red or blue tone. Exposure compensation (For models with an Exposure Compensation Function) Too bright/ too dark • This can adjust the brightness. Auto bracket function (For models with an Auto Bracket Function) • This can record multiple images with different exposure at once. [. . . ] € Remove the digital camera from the Case and then immediately remove the battery from the digital camera. € The temperature inside the Case becomes very high particularly when it is exposed to direct sunlight on a beach, a ship etc. € If a digital camera is attached to the Case, it may also be damaged. € If you use the attached digital camera when the temperature inside the Case is very high, it may cause leakage, short-circuiting or insulation failure resulting in fire or malfunction. [. . . ]