User manual INDESIT NCAA 55

[. . . ] Once the appliance has been installed, the power supply cable and the electrical socket must be easily accessible. The cable must be checked regularly and replaced by authorised technicians only (see Assistance). If the floor is not perfectly horizontal, make the Necessary adjustments by tightening or loosening the single foot at the front of the appliance. The manufacturer declines any liability should these safety measures not be observed. [. . . ] Do not place glass bottles which contain liquids, and which are corked or hermetically sealed in the freezer because they could break. The maximum quantity of food that may be frozen daily is indicated on the plate containing the technical properties located on the bottom left side of the refrigerator compartment (for example: Kg/24h: 4) ?In order to obtain a greater amount of space in the freezer compartment, you may remove the bins (except the lowest bin and the special COOL CARE ZONE bin, which has an adjustable temperature) and place the food directly onto the evaporator plates. Check that the tray is ompletely empty and fill it with water through the opening provided. Excess water prevents the ice cubes from dispensing (if this happens, wait for the ice to melt and empty the tray). Turn the tray 90°: due to the connected compartments each mould fills with water (see diagram). When the ice has formed (minimum time approximately 8 hours) knock the tray against a hard surface and wet the outside so that the ice cubes come loose and take them out through the opening. This will help maintain the temperature inside the freezer, ensuring that foods are conserved for at least 9 -14 hours. If the room temperature drops below 14°C for an extended period of time, the ideal temperature will not be reached in the freezer compartment and food preservation will be reduced. The appliance is fitted with a manual "Fast Freezer" When loading fresh food to freeze switch "Fast Freeze" So when the fresh food is frozen return the switch to Note: for Energy Saving ensure that "Fast Freeze" is For the refrigerator to operate properly the "Fast Freeze" button must be ON when room temperature is 16°C or lower. Switching the appliance off During cleaning and maintenance it is necessary to disconnect the appliance from the electricity supply: It is not sufficient to set the temperature adjustment knobs on (appliance off) to eliminate all electrical contact. The external and internal parts, as well as the rubber seals may be cleaned using a sponge that has been soaked in lukewarm water and bicarbonate of soda or neutral soap. The removable accessories may be soaked in warm water and soap or dishwashing liquid. The back of the appliance may collect dust which can be removed by delicately using the hose of a vacuum cleaner set on medium power. The appliance must be switched off and the plug must be pulled out before cleaning the appliance. GB If the frost layer is greater than 5 mm, it is necessary to defrost manually: 1. Wrap frozen foods in newspaper and place them in another freezer or in a cool place. This can be made easier by placing containers with lukewarm water in the freezer compartment. Clean and dry the freezer compartment carefully before switching the appliance on again. Certain appliances are fitted with the DRAIN SYSTEM to lead the water outside: let the water flow into a container (see diagram). Until the ideal storage conditions have been restored, before placing food in the freezer compartment. The appliance is manufactured with hygienic materials which are odour free. [. . . ] If switch is not in ON position and severe icing persists, set temperature regulating knob (see pag 14 for details) to lower position. Excess moisture / Ice will occur if the Larder door is opened for prolonged periods. This will disappear once the door is closed and the Larder allowed to defrost and drain the moisture away. This is normal for cooling function of the Larder compartment, especially in summer period. [. . . ]