User manual INDESIT VIA 640.1 C

[. . . ] - The power cable must be long enough for connecting the appliance, fitted in the cabinet, to the power supply. - For installation to comply with the current safety regulations, an omnipolar switch with minimum contact gap of 3mm is required. - The electrical parts must not be accessible to the user after installation. The Manufacturer declines any liability for inappropriate use or incorrect setting of the controls. [. . . ] If an undertop oven is installed, make sure the oven is equipped with a cooling system. Do not install the hob above a dishwasher or washing-machine, so that the electronic circuits do not come into contact with steam or moisture which could damage them. To remove the hob, use a screwdriver (not provided) to prise off the perimeter clips on the underside of the appliance. - Installation must be carried out by qualified personnel who know the current safety and - The manufacturerdeclines all liability for injury to persons or animals andfordamage to property resulting fromfailure to observe the regulations - The power cable must be long enough to allow the hob to be removed from the worktop. - Make sure the voltage specifiedon the dataplate locatedon the bottomof the appliance is the same as that of the home. Remove the terminal cover (A) by unscrewing the screw and insert the cover into the hinge (B) of the terminal. Plug the power cord into the clamp and connect the wires to the terminal block as shown in the wiring diagram located near the terminal. For each connection to the network, the hob automatically checks for a few seconds. If the hob has been in use, the residual heat indicator "H" remains lit until the cooking zones have cooled down. If within 10 seconds of switching on, no function is selected, the hob switches off automatically. Place the pot on the cooking zone, switching the hob on, activate the required cooking zone by pressing the corresponding "+" button "0" appears on the display. Deactivation of cooking zones To switch off the cooking zone, press the corresponding "+" and "-" button for more than 3 seconds. The cooking zone switches off and, if still hot, the letter "H" appears on the zone display. Control panel lock This function locks the controls to prevent accidental activation of the hob. To activate the control panel lock, switch the hob on and press the Lock function button for three seconds; an acoustic signal and a luminous indicator near the padlock symbol signal activation. The presence of water, liquid spilled from pots or any objects resting on the button below the symbol can accidentally activate or deactivate the control panel lock. Timer The timer can be used to set the cooking time for a maximum of 99 minutes (1 hour and 39 minutes) for all the cooking zones. Select the cooking zone to be used with the timer, press the timer (see figure) and a beep signals the function. The Timer value can be decreased and increased by keeping the slider function "+" and "-" buttons pressed. When the set time has elapsed, an acoustic signal sounds and the cooking zone switches off automatically. To deactivate the timer, keep the Timer button pressed for at least 3 seconds. The timer display always shows the timer for the selected zone or the shortest timer. [. . . ] To minimise the risk of injury to children, remove the door, plug, and cut the mains cable off flush with the appliance. Dispose of these parts separately to ensure that the appliance can no longer be plugged into mains socket, and the door cannot be locked shut. Repairs and After Sales For product help and advice, repairs, spare parts or accessories, we're here to help. Please note, our advisors will require the following information: Respectez les cotes indiquées sur la figure pour la distance entre le fond de la table de cuisson et la cloison de séparation. [. . . ]