User manual INDESIT WD12X

[. . . ] That the drum's fixing screws have been removed from the back of the washer-dryer; 2. 5) A few handy tips to get the best drying cycle from your appliance. A correct distribution of your laundry is vital to the successful outcome of the wash and the life of the washer-dryer. Learn all the tips and secrets to dividing your linen: colour, type of fabric. 9. 15) With just a bit of care, it will repay you with loyalty and devotion. [. . . ] Then leave it under running water for a few minutes. Cutting costs efficiently A guide to environmentally friendly and economic use of your appliance. MAXIMISE THE LOAD SIZE Achieve the best use of energy, water, detergent and time by using the recommended maximum load size. SAVE detergent, time, water and between 5 to 15% energy consumption by NOT selecting Prewash for slight to normally soiled laundry. Pretreat stains with stain remover or soak dried in stains in water before washing to reduce the necessity of a hot wash programme. SAVE energy and time by selecting the highest suitable spin speed to reduce the water content in laundry before using a drying programme. You cannot bleach with the “Silk” programme and with the “special programmes” (see page 4). Should you want to do it separately you must pour the bleach into the additional container 4, press button G (stain removal), star t the washer-dryer, then select one of the symbols according to the type of fabric. When you bleach during a normal wash cycle, pour the detergent and any additives in the special compartments, press button G (stain removal), set the programme you desire and turn the washer-dryer on. Instructions for installation and use 8 Troubleshooting Before calling, read the following In most cases, when your washer-dryer fails to work, the problems arising can be easily solved without having to call for a technician. The washer-dryer fails to start. Is the plug correctly inserted into the socket?A circuit breaker may have switched off as a result of too many electrical appliances working at the same time. For safety reasons, the washer-dryer cannot work if the door is open or not shut properly. Is the programmed start knob, in the correct position for those models concerned?For safety reasons, if the washer-dryer does not load water, it cannot start a wash cycle. An excessive amount of detergent, besides producing too much foam, does not guarantee a more effective wash, and causes scaling in the internal parts of the appliance. The washer-dryer does not dry. Check whether: the plug has been correctly inserted into the socket; there is electricity in your home; the appliance door has been shut properly; a delayed start (if available) has not been selected; programme knob A has been set to position (Stop/Reset); the drying cycle knob C has been set to position 0. Always get assistance from authorised technicians and always insist on original spare parts. Technical characteristics Model Dimensions WD 12 X width 59, 5 cm height 81, 5 cm depth 54 cm from 1 to 5, 5 kg for the wash programme; from 1 to 4 kg for the drying programme voltage 230/240 Volt 50 Hz maximum absorbed power 2050 W maximum pressure 1 MPa (10 bar) minimum pressure 0, 05 MPa (0, 5 bar) drum capacity 46 litre up to 1200 rpm wash: programme 3; temperature 60C°; carried out with 5 kg load; . drying: run with a load of 2. 5 kg and knob C et to position This appliance conforms with the following E. E. C. directives: - 73/23/EEC of 19/02/73 (Low Voltage) and subsequent modifications - 89/336/EEC of 03/05/89 (Electromagnetic Compatibility) and subsequent modifications The washer-dryer doesn't dry properly. Check whether: the end of the drain hose is underwater; the drain pump is obstructed; the advice given on the maximum loads has been taken; the water tap has been turned on. If, despite all checks, the washerdryer fails to function and the problem persists, call your nearest authorised Customer Service Centre, providing the following information: - the nature of malfunction - the model type no. . . . . ) - the serial number (S/N . . . . ) This information can be found on the data plate situated at the back of the washer-dryer. Capacity Electrical connections Water connections Spinning speed Control programs in compliance with IEC regulation 456 Instructions for installation and use 10 Installation and removal When the new washerdryer arrives Whether new or just transported to a new house, installation is extremely important for the correct functioning of your washer-dryer. After removing the appliance from its packaging, check that it is intact. The inside of the machine is supported, for transportation, by four screws on the back panel. Connection to the water mains Both hot and cold water supplies are preferable and they should be between 34. 5kN/m²(5lb/in²) and 1034. 2kN/m² (150lb/in²) pressure. The hose having the red end fitting should be encountered between the hot supply and the threaded connection adjacent to the letter H on the rear of the machine. The hose having the white end fittings should be connected between the cold supply and the threaded connection adjacent to the letter C on the rear of the machine. Remember to insert a sealing washer at each connection to ensure watertight joints. Do not overtighten the connections by using tools -hand tight is sufficient to prevent leaks. [. . . ] When you use your washer-dryer, water pressure is very strong and a cracked tube could easily split open. 15 Instructions for installation and use Important for the safe use of your washer-dryer Your safety and that of your family Read these instructions and all the information in this manual carefully: they are an important source, not only of numerous useful tips, but also of vital information on safety, use and maintenance. the machine should not be installed in an outdoor environment, not even when a roof shelters the area, because it may be very dangerous to leave it exposed to rain and thunderstorms. It must only be used by adults and exclusively for washing clothes following the instructions provided in this manual. Should it have to be moved, proceed with the help of two or three people and handle it with the utmost care. [. . . ]