User manual INDESIT WIDE 146

[. . . ] If the floor is not perfectly level, compensate for any unevenness by tightening or loosening the adjustable front feet (see figure); the angle of inclination, measured according to the worktop, must not exceed 2°. If the water inlet hose is not long enough, contact Connect the drain hose, without bending it, to a draining duct or a wall drain situated between 65 and 100 cm from the floor; The power supply cable must never be bent or dangerously compressed. The power supply cable must only be replaced by an authorised serviceman. The company denies all liability if and when these norms are not respected. [. . . ] Press it again and the temperature lowers until it reaches OFF, which indicates a cold wash cycle (press it again to go back to the maximum value); stop on the desired value, after approximately 2 seconds the setting is accepted: the symbol remains fixed. If, when the appliance is switched on, the KNOB is set to a programme requiring a drying setting, press button and the display will indicate the word OFF, while icon flashes. Press it again and the Three times (40'-1:20-2:00) and the Three levels of drying available will be displayed in sequence; stop at the desired type of drying; the setting will be accepted after approximately 2 seconds, then will the time for the programme set (including the drying time) will be indicated on the display and the symbol remain on. The drying cycle setting cannot be made with programmes 4-5-8-9-11-12- . : if the KNOB is set to one of the programmes (6-7) dedicated to drying only, icon lights up permanently, press button and the drying level " " will indicated while icon flashes; then to select the desired drying type, proceed as described above. If your laundry load to wash and dry is exceptionally in excess of the maximum load foreseen (see table opposite), perform the wash cycle, and when the programme is complete, divide up the garments and put part of them back in the drum. Dry only Set the PROGRAMME knob to one of the drying settings (6-7) depending on the type of fabric, then select the desired drying type. Important: - A spin cycle is carried out during the drying if you have set a cotton programme. - If you set "spin cycle exclusion", you may not select a drying cycle. If you wish to run a drying cycle, select the maximum spin speed available and then choose the type of drying required. - For cotton loads of less than 1 Kg, use the drying programme designed for delicate fabrics. If you set a function that is incompatible with another function you selected previously, only the last one selected will be enabled. This option reduces the amount of creasing on fabrics, making them easier to iron. Recommended when the appliance has a full load or with large quantities of detergent. When this function is set, programmes 3 and 5 will end, with the laundry left to soak (Anti-crease), and the relative button flashes: - to conclude the cycle, press the START/RESET button or the EASY IRON button; - to run the draining cycle alone, set the knob to the relative symbol and press the START/RESET button. Good washing results also depend on the correct dose of detergent: adding too much detergent won't necessarily make for a more efficient wash, and may in fact cause build up on the interior of your appliance and even pollute the environment. Quilted coats and windbreakers: if they are padded with goose or duck down, they can be machine-washed. Turn the garments inside out and load a maximum of 2-3 kg, repeating the rinse cycle once or twice and using the delicate spin cycle. Wool: for best results, use a specific detergent, taking care not to exceed a load of 1 kg. Indesit sets a new standard of superior performance that has been endorsed by The Woolmark Company with the prestigious Woolmark brand. Look for the Woolmark logo on the washing machine to ensure you can safely and effectively wash wool garments labelled as "hand wash" (M. Compartment 1: Detergent for pre-wash (powder) compartment 2: Detergent for the wash cycle (powder or liquid) Liquid detergent should only be poured in immediately prior to the wash cycle start. [. . . ] If the dwelling is on one of the upper floors of a building, there may be drain trap problems causing the Washer-dryer to load and unload water continuously. In order to avoid such an inconvenience, special anti-drain trap valves are available in shops. The programme does not foresee the draining: some programmes require enabling the draining manually (see page 20). The drum was not unblocked correctly during installation (see page 16). [. . . ]