User manual INDESIT WIXL 125

[. . . ] Remove the 3 protective screws and the rubber bush with the respective spacer, situated on the rear of the appliance (see also the installation leaflet). NB:The plastic spacers may fall down inside the machine once the bolt has been removed, and will not interfere with the operation of the machine. Keep all the parts: you will need them again if the washing machine needs to be moved to another location. A 1. Insert seal A into the end of the inlet hose and screw the latter onto a cold water tap with a 3/4 gas threaded mouth (see figure). [. . . ] To cancel it, keep the START/RESET button pressed for at least 2 seconds. When the programme is finished, the ON-OFF/ DOOR LOCK Led will flash to indicate that the appliance door can be opened. Take out your laundry and leave the appliance door ajar to allow the drum to dry thoroughly. N. B. : Once you have pressed the Start/Reset button, the delay can only be decreased if you wish to modify it. Please remember to pour the bleach into extra compartment 4 (see page 10). When this function is set, programmes 4, 5, 7 will end with the laundry left to soak (Anti-crease) and the Rinse cycle phase LED will flash. - to conclude the cycle, press the START/RESET button; - to run the draining cycle alone, set the knob to the relative symbol and press the START/RESET button. Recommended when the appliance has a full load or with large quantities of detergent. Enabled with programmes: All Delay Timer Stain removal 2, 3, 4, 5, Rinse cycle. Easy iron 3, 4, 5, 7, 8, 9, 10, Rinse cycle. Extra Rinse 1, 2, 3, 4, 5, 8, 9, 10, 12, 13, Rinse cycle. The machine has an intelligent built in check for out of balance loads. To let protect your machine it may reduce the final spin speed if an unbalanced load is detected. The balancing attempts may extend the total duration of the cycle, up to a maximum of 10 minutes. 9 Detergents and laundry GB Detergent dispenser Good washing results also depend on the correct dose of detergent: adding too much detergent won't necessarily make for a more efficient wash, and may in fact cause build up on the interior of your appliance and even pollute the environment. Open up the detergent dispenser and pour in the detergent and fabric softener, as follows. Preparing your laundry Divide your laundry according to: - the type of fabric/the symbol on the label. Should it have to be moved, proceed with the help of two or three people and handle it with the utmost care. Before loading your laundry into the washing machine, make sure the drum is empty. Saving energy and respecting the environment Environmentally-friendly technology If you only see a little water through your appliance door, this is because thanks to the latest Indesit technology, your washing machine only needs less than half the amount of water to get the best results: an objective reached to respect the environment. Saving on detergent, water, energy and time To avoid wasting resources, the washing machine should be used with a full load. A full load instead of two half loads allows you to save up to 50% on energy. Avoiding it will save on detergent, time, water and between 5 and 15% energy. Treating stains with a stain remover or leaving them to soak before washing will cut down the need to wash them at high temperatures. A programme at 60°C instead of 90°C or one at 40°C instead of 60°C will save up to 50% on energy. Use the correct quantity of detergent depending on the water hardness, how soiled the garments are and the amount of laundry you have, to avoid wastage and to protect the environment: despite being biodegradable, detergents do contain ingredients that alter the natural balance of the environment. If you use your washing machine from late in the afternoon until the early hours of the morning, you will help reduce the electricity board's peak load. The Delay Timer option (see page 9) helps to organise your wash cycles accordingly. If your laundry has to be dried in a tumble dryer, select a high spin speed. [. . . ] The Easy iron option is enabled: to complete the programme, press the START/RESET button (see page 9). Remove the drain hose from the standpipe or under-sink trap and check for blockages, ensuring that the water can drain freely away from the machine. When the machine is installed, the locking screws for the oscillating assembly are still in place. The washing machine is closed in between furniture cabinets and the wall (see page 2). [. . . ]