User manual INFINITY SAT-750

[. . . ] INFP1419SAT-750 OM 9/8/03 4:01 PM Page 1 TOTAL SPEAKER SOLUTIONS SAT-750 Owner's Guide INFP1419SAT-750 OM 8/11/03 10:37 AM Page 2 INFP1419SAT-750 OM 8/11/03 10:37 AM Page 3 SAT-750 OWNER'S GUIDE Table of Contents 2 2 2 3 3 4 4 4 Introduction Unpacking the Speaker Placement Wall-Mounting the Satellites Speaker Connections Operation Maintenance and Service Specifications SAT-750 1 INFP1419SAT-750 OM 8/11/03 10:38 AM Page 4 INTRODUCTION Infinity Total SolutionsTM Infinity Total Solutions continues Infinity's longstanding commitment to accurate sound reproduction. Our proprietary Metal Matrix Diaphragm (MMDTM) drivers, precision dividing networks and rigid, well-braced enclosures combine to deliver uncompromised performance in any stereo or multichannel home theater system. In addition, these speakers, except for the powered subwoofer, are magnetically shielded for safe placement adjacent to a television. Home Theater For front-channel use, place one speaker on the left and another on the right, along either side of the television monitor. [. . . ] · Refer to "Home Theater" below if you also plan to use the speakers for home theater reproduction. Left Front Channel Center Channel Right Front Channel Couch Left Surround Channel Left Rear Channel Center Rear Channel Right Rear Channel Right Surround Channel Figure 2. This overhead view shows a typical home theater plan. Center rear channel is for a 6-channel system. (optional) Left Channel Right Channel Listening Position Figure 1. This overhead view shows typical positioning in stereo applications. Left Rear Channel Right Rear Channel Center Rear Channel Figure 3. This figure shows an alternate layout, which may be more suitable for some rooms. Center rear channel is for a 6-channel system. 2 SAT-750 INFP1419SAT-750 OM 8/11/03 10:38 AM Page 5 WALL-MOUNTING THE SATELLITES The SAT-750 satellites are designed to be mounted on the wall. Each speaker bracket will require (2) 1-1/2, " #10 wood screws; each screw should be fastened to a wall stud. If a wall stud is unavailable, install an anchor appropriate for a 1-1/2, " #10 screw. NOTE: The customer is responsible for the correct selection and use of mounting hardware (available through hardware stores) that will ensure the proper and safe wall-mounting of the speakers. Mark the positions on the wall where you would like to place the mounting screws. Place bracket against wall and fasten two 1-1/2, " #10 wood screws through the bracket's screw holes into the wall. Place the speaker on the wall by sliding the opening on the bottom of the speaker over the bracket hook on the wall. Once positioned properly, the speaker should slide down slightly and become secure. Once positioned properly, the speaker should slide down slightly and become secure. SPEAKER CONNECTIONS Turn Off All Power First, turn off all audio-system power. For longer distances, #16-gauge or heavier wire is recommended. The side of the wire with a ridge or other coding is usually considered positive polarity (i. e. , +). Also, consult the owner's manuals that were included with your amplifier or receiver to confirm connection procedures. Observe polarities when making speaker connections, as shown in Figure 5. Connect each + terminal on the back of the amplifier or receiver to the respective + (red) terminal on each speaker. Connect the ­ (black) terminals in the same way. Important! Do not reverse polarities (i. e. , + to ­ or ­ to +) when making connections. [. . . ] If the problem appears in the opposite speaker, the cause is in another component or cable. In the event that your SAT-750 ever needs service, contact your local Infinity dealer or Infinity directly at 516-674-4INF (USA only) or www. infinitysystems. com for a service center near you. Midrange Driver(s): High-Frequency Driver: Dimensions (H x W x D): Weight: Infinity continually strives to update and improve existing products, as well as create new ones. The specifications and construction details in this and related Infinity publications are therefore subject to change without notice. 4 SAT-750 INFP1419SAT-750 OM 8/11/03 10:38 AM Page 7 NOTES INFP1419SAT-750 OM 8/11/03 10:37 AM Page 8 © 2003 Harman International Industries, Incorporated Infinity Systems, 250 Crossways Park Drive, Woodbury, NY 11797 USA 516. 674. 4INF (USA only) www. infinitysystems. com * Trademarks of Dolby Laboratories. Infinity is a registered trademark, and Total Solutions and MMD are a trademarks, of Harman International Industries, Incorporated. [. . . ]