User manual INFINITY TSS-CENTER4000

[. . . ] TSS-4000 TOTAL SPEAKER SOLUTIONS TSS-CENTER4000 Owner's Guide INTRODUCTION Infinity Total SolutionsTM Infinity Total Solutions TSS-CENTER4000 center channel loudspeaker is designed to perfectly complement the TSS-SAT4000 speakers. It uses identical drivers to provide exceptional dialogue reproduction and a seamless transition between the front channels. The horizontal design allows for maximum placement flexibility. PLANNING YOUR SYSTEM Before deciding where to best place your speakers, survey your room and study Figures 1 and 2. Left Front Channel Center Channel (above or below TV) Right Front Channel Subwoofer About This Guide Please read this guide completely before connecting and operating the TSS-CENTER4000 center channel speaker. [. . . ] The powered subwoofer provides bass for effects and music. Contents Please verify that the package contains the following items: Placement (1) TSS-CENTER4000 center channel speaker Part A Part B (2) Wall-mount end caps (attached to satellite) Figure 2. This example shows the TSS-CENTER4000 being placed on top of a television. The speaker can also be placed below the television and tilted up (see Figure 3). (1) Allen wrench (1) Speaker base (1) Wall bracket with wall bracket cover 2 TSS-CENTER4000 Tilting the Speaker If needed, the enclosed stand allows you to tilt the speaker across a wide range (i. e. , up a maximum of 18° or down a maximum of 7°), as shown in Figure 3. Doing so may cause the speaker to fall out of its stand. Wall-Mounting the TSS-CENTER4000 Using the Included Wall Bracket The customer is responsible for proper selection and use of mounting hardware, and for correctly and safely wall-mounting the speakers. Step One Remove the wall bracket cover by removing the four wall bracket screws on the ends as shown. Step Two Run the speaker wire behind the wall bracket and out the hole in the center. After deciding where to place the center speaker, attach the wall bracket (in a horizontal position) to the wall using the appropriate screws and anchors. Center Hole Figure 3. Wall Bracket Mounting Screws and Anchors Not Included Step Three Run the speaker wires out through the hole in the center of the wall bracket cover. Resecure in place with the four wall bracket screws, as shown. TSS-CENTER4000 3 Step Four Using the included Allen wrench, remove the top and bottom end caps of the speaker by unscrewing the single center screw on bottom. Step Six The wall-bracket design allows for rotation of the speakers at angles up to 30 degrees of center. Position the speakers so they face toward the primary listening position, before fully tightening. End Cap End Cap 1/4-20 x 3/4" Screw Step Five Connect the wires (page 5). Replace the end caps while capturing the wall bracket between parts A and B of the end cap, securing it in place. Wall-Mount End Cap B Wall-Mount End Cap A 4 TSS-CENTER4000 WIRING THE SPEAKER After placing the speaker, you are ready to connect it to your system. Consult the owner's manuals included with your amplifier or receiver for connection and operation procedures. CARE OF YOUR SPEAKER SYSTEM When needed, use a soft cloth to remove any fingerprints or to wipe off dust. Clean the grille by gentle vacuuming. Surround Modes When using the TSS-CENTER4000 in a Dolby* Digital or DTS® home theater system, make sure the receiver's/processor's center channel speaker modes are set to "Small. " Wiring and Polarity The TSS-CENTER4000 speaker has gold-plated terminals that can accept bare wire. To ensure proper polarity, connect each + terminal on the back of the amplifier or receiver to the respective + (red) terminal on each speaker, as shown in Figure 4. See the owner's manuals that were included with your amplifier or receiver to confirm connection procedures. Important! Do not reverse polarities (i. e. , + to ­ or ­ to +) when making connections. [. . . ] The specifications and construction details in this and related Infinity publications are therefore subject to change without notice. Declaration of Conformity We, Harman Consumer International 2, route de Tours 72500 Chateau-du-Loir France declare in own responsibility that the product described in this owner's manual is in compliance with technical standards: EN 61000-6-3:2001 EN 61000-6-1:2001 Robin Marshall Harman Consumer International Chateau-du-Loir, France 10/04 6 TSS-CENTER4000 NOTES © 2004 Harman International Industries, Incorporated Infinity Systems, 250 Crossways Park Drive, Woodbury, NY 11797 USA 516. 674. 4INF (USA only) www. infinitysystems. com * Trademarks of Dolby Laboratories. Infinity and MMD are registered trademarks, and Total Solutions is a trademark, of Harman International Industries, Incorporated. [. . . ]