User manual INFOCUS TD40 DOCUMENT

[. . . ] 1 To fine tune a channel, press the Menu button on the remote control. (See Remote Control FAQs for information about using the remote control. ) Adjust the internal tuner using the VOL+ and VOL­ keys until you get the best image. If that is ineffective, consider upgrading the antenna. 2 2 3 Can I use a high definition set top digital cable box with the TD40? [. . . ] After the first fourteen channels appear, the next 14 (if available in memory) appear one at a time. The image on a specific channel should be color but is black and white. 1 2 Press the Menu/Set button, and use the VOL­ to navigate to the TV menu. On the TV menu, use the CH­ to select Fine Tune, and then press the Menu/Set button. When you finish, press the Back button until the menus disappear. 2 No image or very poor image on a specific channel. If it is not, tune in the channel with the remote control keypad, then press the CH ADD button. (See Remote Control FAQs for information about using the remote control. ) Adjust the internal tuner using the VOL+ and VOL­ keys until you get the best image. If the fine tuning is ineffective, this is probably a cable or antenna issue. If you have an antenna, try adjusting the antenna. 6 7 8 Jittery or shaky image 1 Confirm that the video signal is compatible with the TD40. The NTSC version is compatible only with NTSC standard video, and the PAL version is compatible only with PAL/SECAM video. If you play PAL or SECAM video through the NTSC version, the image is likely to be unstable, noisy, or may be in black and white. If the video image does not shake, the issue probably lies with the cable or antenna. Press the Picture button on the remote control to cycle through the four settings. To customize any of the settings, see How do I change the color, contrast, and tint?Picture modes include settings for brightness, contrast, tint, sharpness and color saturation. You can change the three preset modes to suit your taste, and you can create a user-defined mode. 1 Press the Menu button on the remote control, then select Mode in the Picture menu. 2 2 Use the CH­ button to cycle through the four mode choices: Standard (default), Vivid (higher contrast and saturation), Mild (lower contrast and saturation), and User (your personal settings). 3 When you select a mode, the picture changes. If one of the preset modes is satisfactory, press the Back button until the menu disappears. [. . . ] If the lines do not appear, there is an issue with the incoming signal. Channels arbitrarily change from one to another Turn the unit off, and then unplug the power cord. Only a blue screen or video noise appears, or the channels are skipped. [. . . ]