User manual IOGEAR GBP201

[. . . ] PKG-M0111 IOGEAR, the IOGEAR logo, MiniView, VSE are trademarks or registered trademarks of IOGEAR, Inc. Microsoft and Windows are registered trademarks of Microsoft Corporation. IBM is a registered trademark of International Business Machines, Inc. [. . . ] Due to the fact that all printer manufacturers have somewhat different procedure to install the printer driver, we do not cover the printer driver installation in this manual. Also, we do not cover the procedures of installing Bluetooth driver to your computer, we assume the computer is already Bluetooth enabled. If you are using an IOGEAR Bluetooth USB adapter, please refer to the manual for that unit for the detailed procedures. The example below uses Epson C62 as the printer, the printer driver is installed after the installation of the Bluetooth print adapter. Here are the steps: Turn off the power of the printer; Connect the Bluetooth print adapter to the printer using the USB B-B cable; Turn on the power for the printer and plug the power adapter on the print adapter; Configure the print adapter: 7 Installation 1. From the Bluetooth enabled computer, click the Bluetooth logo on your screen, then click My Bluetooth Place, then select Entire Bluetooth Neighborhood. 8 Installation 2. You can see that the computer starts searching for the Bluetooth devices within the range. The Bluetooth print adapter should be found as shown in the follow window: 9 Installation 3. (This question would not be prompted if the printer driver is already installed. ) 10 Installation 4. The following window will be prompted for you to select the appropriate driver. (This step would be skipped if the printer driver is already installed. ) 11 Installation 5. After the driver installation, go to Control Panel, and select Printers, the printer that you just installed should be in the following window: 12 Installation 7. Right click the printer icon (in this case the Epson C62), select Properties from the drop down menu. 13 Installation 8. Select Ports on the Printer Properties screen, and check the IOGEAR print adapter port, then click OK. 14 Installation 9. [. . . ] This equipment has been tested and found to comply with the limits for a Class B computing device pursuant to Subpart J of Part 15 of FCC Rules, which are designed to provide reasonable protection against such interference when operated in a commercial environment. Operation of this equipment in a residential area is likely to cause interference, in which case the user at his own expense will be required to take whatever measures may be required to correct the interference. 20 Limited Warranty IN NO EVENT SHALL THE DIRECT VENDOR'S LIABILITY FOR DIRECT, INDIRECT, SPECIAL, INCIDENTAL OR CONSEQUENTIAL DAMAGES RESULTING FROM THE USE OF THE PRODUCT, DISK OR ITS DOCUMENTATION EXCEED THE PRICE PAID FOR THE PRODUCT. The direct vendor makes no warranty or representation, expressed, implied, or statutory with respect to the contents or use of this documentation, and especially disclaims its quality, performance, merchantability, or fitness for any particular purpose. [. . . ]