User manual IOMEGA DESKTOP ESATA GUICK GUIDE

[. . . ] Push the connector on the eSATA card FIRMLY into the slot, then replace the slot cover screw. NOTE: Push firmly and evenly on the top edge of the card until it snaps into place. The connector should seat evenly on both ends of the PCI slot to ensure a good connection. [. . . ] NOTE: If you receive a message during reboot indicating a non-system disk, no boot partition or no boot disk, refer to Troubleshooting on page 20. Anslut den medföljande strömkabeln till enhetens baksida och koppla den därefter till ett strömuttag. För att inte skada elkontakten, se till att den är riktad rätt innan du ansluter den till enheten. Koppla in eSATA-datakabeln till enheten och till kontakten på eSATA-kortet. The eSATA interface is not hot-plug-and-play, so always turn off power to the drive and computer before disconnecting. Close all files and folders on the drive and make sure there is no drive activity for at least 15 seconds before turning off power to the drive. To avoid data loss, make sure any data transfers are complete before turning off power to the drive. After the eSATA drivers are installed, the system will recognize the drive if it is reconnected while the computer is powered up. If the drive is connected while the computer is on, it can cause the drive to turn on automatically. Always make sure the drive is placed on a stable surface before reconnecting to the computer or turning on power to the drive. Lock the bottom plate tabs securely into the vent slots on the side of the drive opposite the drive access light. On some models the registration number is stored under the drive's bottom plate. To find the serial number, remove the bottom plate from the hard drive (as shown in the first illustration above). Iomega recommends periodic system backups and more frequent data backups to ensure that your critical data is always protected. [. . . ] To manually install the drivers, follow the instructions for your operating system. A complete user's manual in HTML format is available on the Support & Downloads area on www. Iomega, the stylized "i" logo, and all Iomega brand blocks are either registered trademarks or trademarks of Iomega Corporation in the United States and/or other countries. [. . . ]