User manual IOMEGA DESKTOP HARD DRIVE USB 2.0 QUICK GUIDE

[. . . ] Save or drag and drop files to the drive as you would to any other drive attached to your computer. För att inte skada elkontakten, se till att den är riktad rätt innan du ansluter den till enheten. Spara eller dra och släpp filerna till enheten precis på samma sätt som du skulle göra med vilken annan hårddisk som helst som anslutits till datorn. Make sure the drive is receiving power (check if the status light is on). [. . . ] Make sure the drive is receiving power (check if the status light is on). connect the data cable directly to the port on the computer or on the USB card. 0 host adapter, make sure that the correct drivers for the adapter have been installed and the operating system recognizes it. 3, format the drive HFS+ or partition the drive into smaller volumes (less than 127GB). If the drive is still not assigned a drive letter, please visit the Support & Downloads area on www. If your PC will not start up when the drive is connected, there is probably a conflict with the computer. To work around this problem, power off the drive when starting the computer. A complete user's manual in HTML format is available on the Support & Downloads area on www. Iomega warrants this hardware product to be free from defects in materials and workmanship for the warranty period. This non-transferable, limited warranty is only to you, the first end-user purchaser. Some jurisdictions do not allow disclaimers of implied warranties or limitations on how long an implied warranty lasts, so the above limitation may not apply to you. This warranty gives you specific legal rights and you may also have other rights that vary from jurisdiction to jurisdiction. Any suit for breach of any warranty on your Product must be filed within one (1) year of the first date the suit could have been brought. Operation is subject to the following conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of more or the following measures: · Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. This Iomega product conforms to the following European Directive(s)and Standard(s): Application of Council Directives: 73/23/EEC, 89/336/ EEC. [. . . ] However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of more or the following measures: · Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. This Iomega product conforms to the following European Directive(s)and Standard(s): Application of Council Directives: 73/23/EEC, 89/336/ EEC. In accordance with European Directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE), the presence of the above symbol on the product or on its packaging indicates that this item must not be disposed of in the normal unsorted municipal waste stream. [. . . ]