User manual JBSYSTEMS IMOVE 5S ELC-HID V1.0

[. . . ] The minimum distance between light-output and the illuminated surface must be more than 1 meter. To protect the environment, please try to recycle the packing material as much as possible. To prevent fire or shock hazard, do not expose this appliance to rain or moisture. To avoid condensation to be formed inside, allow the unit to adapt to the surrounding temperatures when bringing it into a warm room after transport. [. . . ] Make sure the area below the installation place is free from unwanted persons during rigging, de-rigging and servicing. Locate the fixture in a well ventilated spot, far away from any flammable materials and/or liquids. The device should be installed out of reach of people and outside areas where persons may walk by or be seated. Before rigging make sure that the installation area can hold a minimum point load of 10times the device's weight. Always use a certified safety cable that can hold 12times the weight of the device when installing the unit. This secondary safety attachment should be installed in a way that no part of the installation can drop more than 20cm if the main attachment fails. The device should be well fixed; a free-swinging mounting is dangerous and may not be considered!Don't cover any ventilation openings as this may result in overheating. The operator has to make sure that the safety-relating and machine-technical installations are approved by an expert before using them for the first time. The installations should be inspected every year by a skilled person to be sure that safety is still optimal. Hold the lamp socket while unplugging the lamp instead of pulling the cable!Hold the lamp socket while pressing the new lamp gently in the socket. Check the label on the backside of the device or see the technical specifications in this manual to know which lamp should be used. Lamps with higher wattage generate temperatures the device was not designed for. if the device uses a lamp transformer , it will burn due to current overload. If you touched the lamp, clean it with a cloth and a little denatured alcohol. DMX INPUT/OUTPUT: For DMX512 link, use 3-pin XLR plug cable to link the unit together. MAIN MENU: To select any of the pre-set functions, press the MENU button up to when the required one is shown on the display. After 8 seconds the display will automatically return to the main functions without any change. Once the correct address shows on the display, press the ENTER button to save it. (or automatically return to the main functions without any change after 8 seconds) To go back to the functions without any change press the MENU button again. Show 3 mode - Fixture is placed on the speaker, The spot is always projecting to the audience's direction; i. [. . . ] Its DMX input will have nothing plugged into it, and its masterLED will be constantly on and sound-LED will flash to the music. This function only works when the blackout mode in the menu of the master is set to OFF, otherwise nothing will happen! mASTER has 2 built-in shows: You can select (show 1) , (show 2) , (show 3) or (show 4) directly in the menu of the master. SLAVES have 2 working options: The other units are set to slave mode (slave-LED is constantly on). [. . . ]