User manual JBSYSTEMS PATRIOT V1.0

[. . . ] ⷠKeep this booklet in a safe place for future consultation. To protect the environment, please try to recycle the packing material as much as possible. ⷠA new light effect sometimes causes some unwanted smoke and/or smell. ⷠTo prevent fire or shock hazard, do not expose this appliance to rain or moisture. [. . . ] Apart from the lamp and mains fuse there are no user serviceable parts inside. Always replace a damaged fuse with a fuse of the same type and electrical specifications! ⷠIn the event of serious operating problems, stop using the fixture and contact your dealer immediately. ⷠThe housing and the lenses must be replaced if they are visibly damaged. ⷠPlease use the original packing when the device is to be transported. ⷠDue to safety reasons it is prohibited to make unauthorized modifications to the unit. Don't use the effect in the presence of persons suffering from epilepsy. Hanging bracket with knob to fasten the unit and a mounting hole to fix a mounting hook. Tomahawk: equipped with an extra 90° sweeping scan mirror Patriot: equipped with an extra special quad angled 90° sweeping scan mirror Exercet: not available Important: The installation must be carried out by qualified service personal only. Improper installation can result in serious injuries and/or damage to property. Working load limits should be respected, certified installation materials should be used, the installed device should be inspected regularly for safety. ⷠMake sure the area below the installation place is free from unwanted persons during rigging, derigging and servicing. ⷠLocate the fixture in a well ventilated spot, far away from any flammable materials and/or liquids. ⷠThe device should be installed out of reach of people and outside areas where persons may walk by or be seated. ⷠBefore rigging make sure that the installation area can hold a minimum point load of 10times the device's weight. ⷠAlways use a certified safety cable that can hold 12times the weight of the device when installing the unit. This secondary safety attachment should be installed in a way that no part of the installation can drop more than 20cm if the main attachment fails. ⷠThe device should be well fixed; a free-swinging mounting is dangerous and may not be considered! ⷠDon't cover any ventilation openings as this may result in overheating. ⷠThe operator has to make sure that the safety-relating and machine-technical installations are approved by an expert before using them for the first time. The installations should be inspected every year by a skilled person to be sure that safety is still optimal. In case of replacement of the lamp or maintenance, do not open the fixture within 10 minutes until the unit cools down after switching off. [. . . ] ⷠHousings, fixations and installations spots (ceiling, truss, suspensions) should be totally free from any deformation. ⷠWhen an optical lens is visibly damaged due to cracks or deep scratches, it must be replaced. ⷠThe mains cables must be in impeccable condition and should be replaced immediately when even a small problem is detected. In order to protect the device from overheat the cooling fans (if any) and ventilation openings should be cleaned monthly. [. . . ]