User manual JENSEN JCR-222

[. . . ] They are provided for ventilation and are necessary to ensure reliable operation of the TV and to protect it from overheating. This TV should never be placed near or over a radiator or heat register. 5) Do not overload electrical outlets or use extension cords as this can result in a risk of fire or electric shock. 6) Never push objects of any kind into this TV through openings as they may touch dangerous voltage points or short-circuit parts that could result in a fire or electric shock. [. . . ] NOTE: To facilitate wiring, connect all wires to the rear of the unit before attaching to the cabinet. Connect your TV antenna or cable system to the antenna connector on the rear of the VE-640. Plug the AC wire into the AC input connector on the rear of the VE-640 and then into the wall. If using the speaker phone feature, plug the VE-640 into a phone jack. Route the wires safely away from heat and moisture sources and secure them in place, using the self adhesive wire mounting clip provided. -5- FRONT PANEL CONTROLS 1) REMOTE INFRARED SENSOR-This sensor receives infrared signals from the hand held remote control unit. 3) FM/AM INDICATOR-When illuminated, the VE640 is set to receive AM or FM radio broadcast. 4) AM/PM INDICATOR-When illuminated indicates PM, not illuminated indicates- AM. 5) LCD-DISPLAY- Displays the channel number, FM/AM frequencies, the time of day and Auxillary Input (AU). 6) CH 1 INDICATOR-When illuminated, the VE-640 is tuned to the preset channel 1. 7) CH 2 INDICATOR-When illuminated, the VE-640 is tuned to the preset channel 2. 8) CH 3 INDICATOR-When illuminated, the VE-640 is tuned to the preset channel 3. NUMERICAL BUTTONS (1- 9, 0) Use these buttons to make a direct channel selection. The channel number chosen will be displayed on the front panel of the VE-640. CHANNEL UP/DOWN BUTTONS (CH) Use these buttons to advance to the next higher or lower channel. VOLUME UP/DOWN BUTTONS (VOL) Use these buttons to increase or decrease the volume. FM/AM BUTTON (FM/AM) Each time this button is pressed, the VE-640 will alternate between AM and FM stereo. The mute feature may also be released by pressing the VOLUME UP/DOWN BUTTONS. CLEAR BUTTON (CLR) Press this button to erase an incorrect channel entry. TELEPHONE BUTTON (TEL) Press this button to answer your telephone from your VE-640. SEEK BUTTONS (SEEK) Tunes the VE-640 to next station of sufficient signal strength. ENTER (ENT) Pressing the enter button (ENT) will cause the channel change to occur immediately. TV-Select TV function. -8- OPERATION TURNING THE VE-640 ON/OFF 1) Press the ON/OFF button to turn the unit on. [. . . ] 3) Press the SET again to display the cable system mode (Standard, IRC, HRC). 4) Press the channel 1 button to select the cable mode (STD/IRC/HRC). -9- OPERATION CONTINUED SETTING THE PRESETS (FOR AM AND FM RADIO OR TV MODES) 1) Tune to the desired channel. 3) Select desired Preset (Channel 1, 2, or 3) and the LED adjacent to the preset will illuminate to confirm selection. Problem Poor Reception Solution Verify Tuner setting matches Antenna / Cable broadcast system. Verify Tuner setting matches Antenna / Cable broadcast system. Try other system types with the TV/CATV BUTTON of the remote control. [. . . ]