User manual JENSEN SMPV-4GBED DATASHEET

[. . . ] Position the panel gasket between the unit and the dashboard, and use the four screws provided to mount the unit securely to the dashboard. Note: Installation instructions must be followed precisely to ensure that the unit maintains IPX5 waterproof standards. Press the power button (1) or any other button on the front of the radio (except the eject button) to turn the unit on. The unit will turn on to the mode that was in use when it was last powered down. [. . . ] Pressing DISP (6) will show the time for five seconds before reverting to the frequency display. Pressing DISP will show the radio frequency for five seconds before reverting to the clock display. Pressing DISP will show the time until DISP is pressed again to return to the frequency display. Press DIM (7) for more than two seconds to adjust the brightness of the LCD backlight. In radio, CD, CDC and Auxiliary modes, the unit will toggle between the clock and the applicable music information (radio frequency, disc/track information, etc. Use a ballpoint pen or other thin metal object to press the reset button under the following circumstances: after the completion of initial installation/wiring, if none of the function buttons work or if an error symbol appears in the display. The reset button is located above the disc slot, which is visible only when the plastic panel covering the slot is pulled out. To restore all factory settings, press and hold MODE until "EEP INIT" appears in the display. Press BAND (13) to change between three FM bands, two AM bands and the weather band. Press CHANNEL << (14a) or CHANNEL >> (14b) momentarily, and the unit will automatically tune to the next strong station. Press CHANNEL << or CHANNEL >> for more than three seconds to enter manual tuning mode. When no CD is present, pulling down the plastic disc cover and pressing the eject button for several seconds will help the player eject any debris from the disc slot. Press CHANNEL << (27a) or CHANNEL >> (27b) momentarily to advance to the next or previous track on the CD. Press and hold CHANNEL << or CHANNEL >> to fast forward or fast reverse through the disc. Number does not appear on the disc, "NO TRACK" will appear on the display. Access a track directly using the numbered buttons (28) on the bottom of the unit (0-9). Direct track access allows for the selection of either a one-digit or two-digit track number. for example , press the "1" button , and "T-01" will flash on the display. If track 1 is the desired track, wait several seconds and the unit will access the track. However, if track 12 is the desired track, press the "2" button while "T01" is still flashing. "T-12" will appear on the display , and track 12 will be accessed. If the selected track number does not appear on the disc, "NO TRACK" will appear on the display. [. . . ] Refer to the owner's manual included with the CD changer for instructions on installing, loading and using the CD magazine. When accessing CDC mode, disc play will begin with the first CD that the unit detects, and the disc and track numbers will be shown in the display. To select the desired disc for play, press SHIFT/SCAN (34) to enter shift mode, and "SHIFT" will appear on the display. Press CHANNEL << or CHANNEL >> select the previous or next disc, or use the numbered buttons (0-9) to select the disc number directly. [. . . ]