User manual JENSEN SMPV-XGBEF DATASHEET

[. . . ] Under these conditions, use extra caution during installation to avoid causing a short circuit. Do not install the unit in the following locations: · Locations exposed to high pressure water spray In areas subject to extreme temperatures Incorrect installation can cause the sound to "skip" when playing a disc. Mount the unit firmly in place using the supplied brackets and screws. Do not use any of the screws that are part of the brake or steering system to install the unit. [. . . ] Make certain the changer is easily accessible for loading and unloading the CD magazine. The 15 foot long data cable will reach the radio connection when routed from the changer. If the springs are not set correctly for the type of installation chosen, the anti-vibration compensation will not be effective, and vibration may cause the disc to skip. Set the antivibration board position with a screwdriver before attaching the brackets. After setting the proper angle before installation, place two pieces of the larger plastic film (supplied) over the built-in anti-vibration boards to prevent water entry. Make sure the anti-vibration springs are set to position "0". Attach a bracket (A) to each side of the unit using the machine screws (M4x5). Attach the brackets (A) to the mounting base (B) using the hexagonal bolts (M6x12) and M6 flat and split washers. Stick the supplied double-sided tape to the bottom of the mounting bases (B) and peel off the paper backing. Stick the supplied double-sided tape to the bottom of the mounting bases (B) and peel off the paper backing. Stick the supplied double-sided tape to the bottom of the mounting bases (B) and peel off the paper backing. Stick the supplied double-sided tape to the bottom of the mounting bases (B) and peel off the paper backing. Use RTV (silicone sealer) on screw threads or around the holes to prevent moisture intrusion. Quite los pernos hexagonales adhiriendo los soportes (A) a la base de montaje (B) y quite el cambiador de la base (Paso 3 para referencia). Using a knife, cut holes in the carpet directly above the bracket's bolts. Mettez la bande à deux faces fournie en bas des bases de montage (B) et éplucher le support en papier. Use the hexagonal nuts to re-attach the changer, on top of the carpet, to the mounting bases (B). Make sure the anti-vibration springs are set to position "0". Attach a bracket (A) to each side of the unit using the machine screws (M4x5). Follow the wiring instructions carefully, or have the installation handled by an experienced technician. [. . . ] Follow the wiring instructions carefully, or have the installation handled by an experienced technician. After completing all connections, press the RESET button on the commander unit (see "Using the Reset Button" on page 16). First, connect the right-angle connector end of the data cable to the 8-pin socket on the back of the changer. When routing wires and cables from the changer to the radio, it is best to conceal the wires. [. . . ]