User manual JENSEN VOYAGER CSW3007 INSTALLATION

[. . . ] [. . . ] Remove crank, spring, directional handle, & 4 screws. TooLs & suppLies 1 · DrillorBatteryDriverwitha#2Philipsbit 2 · PuttyKnife 3 · 3/32"Allenwrench 4 · ElectricalTape 5 · ExteriorRoofSealant(Non-hardeningtype) 2 3 Remove sealant & screws from base, remove antenna and clean surface 4 Apply sealant to all holes & attach exterior plate using the included hardware 5 Apply sealant to holes and attach base using the included hardware. 8 install interior plate using included hardware over hole in ceiling. AsA eLeCTRoNiCs CoRpoRATioN 8) Install interior plate using included hardware over hole in ceiling 8) Install interior plate using included hardware over hole in ceiling www. jensenrvdirect. com www. asaelectronics. com © 2010 AsA electronics Corporation R in Refer to the ANHD20 installation/operation for additional installation details. 6 Apply sealant to 3 screws, fill coax hole, connect coax to antenna and wrap connection with insulating electrical tape. Coax connection should be located inside vertical stalk of antenna for service. 9) Remove plate from wall and disconnect all wires and wires and power/ground cables (note 9 Remove plate from wall and disconnect all cables labels) polarity & cable(note power/ground polarity & cable labels). 9) Remove plate from wall and disconnect all wires and cables (note power/ground polarity & cable labels) 7 7) Attach antenna to base and seal all seams and screws on plate and antenna base 7) Attach antenna to base and seal all seams and screws on plate and antenna base Attach antenna to base and seal all seams and screws on plate and antenna base. 10 10) Connect appropriate cables / wires and install new plate. Tape all coax connections. 8) Install interior plate using included hardware over hole in ceiling Refer to the ANHD20 Installation / Operation for additional [. . . ] [. . . ]