User manual JENSEN VOYAGER JHD1510

[. . . ] l Accessing a Power Source: The power source you choose must be ON for the transmitter and camera to power up. [. . . ] l Routing Wires: When routing the camera extension cables from the camera, choose a route that will protect the cable from sharp objects and debris that could damage the cable. Installing the Receiver (WLO24RX) The receiver comes pre-attached to the LCD monitor in the AOM56WXSYS kit for easy installation. Attach the supplied suction cup mount to the back of the receiver/monitor using the screw supplied (see Figure 1). Place the receiver/monitor in a location that will not obstruct your ability to safely operate and view outside your vehicle. The channel switches for the transmitter are located behind the rubber plug on the bottom outside of the transmitter. The channel switches for the receiver are located on the side of the receiver. CAMERA 1 2 3 4 TRANSMITTER 1 2 3 4 IMPORTANT NOTE: This system operates at 2. 4GHz and may interfere with or be interfered by devices that operate on the same frequency (i. e. Encountering short periods of interference while driving is considered normal operation. [. . . ] If you experience severe interference or picture distortion, change the transmitting/receiving channel (see "Choosing a Transmission Channel). [. . . ]