User manual JENSEN VOYAGER JHD905

[. . . ] Hand tighten only. Regular Mounting Overhead Mounting 4 JHD905 Wiring The wiring diagram depicts all the wiring connections required for proper operation of the unit. Antenna Connector (Black Wire) 9-Pin Connector (Male) NOTE: Do not connect the red wire to a constant power connection. It should be connected to a vehicle connection with switched power, such as IGN or ACC. 3A Fuse Left Speaker + (White) Accessory (Red) Left Speaker (White/Black) Ground (Black) Right Speaker + (Gray) Right Speaker (Gray/Black) 5 JHD905 Basic Operation 1. [. . . ] When no adjustment is made for ten seconds, the time will be set and normal operation will resume. 9. Audio and Menu Adjustment Audio Adjustment Press AUDIO/MENU (9) momentarily to step through the following audio adjustment options: Bass, Treble and Balance (left to right). When the desired option appears in the display, press VOL+ (7a) or VOL- (7b) to adjust that audio feature. When no adjustments have been made for three seconds, the unit will resume normal operation. Menu Adjustment Press the AUDIO/MENU button (9) for more than three seconds to enter menu adjustment mode and adjust any of the menu options. When the desired option appears in the display, press VOL+ (7a) or VOL- (7b) to adjust that option. When no adjustments have been made for three seconds, the unit will resume normal operation. The following menu options may be adjusted using this feature: · · · · · · · Beep Confirm (On or Off) - Determines if a beep will be heard each time a button is pressed. Operation Region (USA or Euro) - Selects the appropriate operating region. Clock Display (12 or 24) - Selects a 12-hour or 24-hour clock display. Display Brightness (Low, Mid or High) - Determines brightness level of the display. Backlight Color (Amber or Green) - Determines the backlight color of the unit. Turn On Volume (0-40) - Selects desired volume level for the unit to assume when turned on. WB Alert (On or Off) - Determines if the weather band alert feature is activated. 7 JHD905 Tuner Operation 10. Select a Band Press AM/FM (10) momentarily to directly access tuner mode from any other function mode. [. . . ] Cause Corrective Action Vehicle ignition switch is not on If the power supply is connected to the vehicle accessory circuits but the engine is not moving, switch the ignition key to "ACC" The 3A fuse is blown No reception Radio does not work Volume too high or too low when the radio is turned on Volume turned down too low Wiring not connected properly Antenna cable not connected Replace the 3A fuse Adjust volume until sound is heard Check wiring connections Insert antenna cable firmly Preset volume is set incorrectly Use the Menu adjustment (page 7) to change preset volume to desired level Turn radio off and allow to cool down Program to "USA" (setup menu) Program to "on" (setup menu) LCD display is dark and Radio too hot difficult to read No WB function Weather alert does not function Programmed to "European" Weather alert programmed to "off" NOTE: Proper care and cleaning is essential to optimal operation. The JHD905 may be cleaned with mild detergent/water mixture and a soft cloth to remove grease and grime. [. . . ]