User manual JENSEN VOYAGER VCCS150

[. . . ] Do not use CDs with labels or stickers attached or that have sticky residue from removed stickers. Do not expose discs to direct sunlight or heat sources such as hot air-ducts, or leave them in a vehicle parked in direct sunlight where there can be a considerable rise in temperature inside the vehicle. NOTE: A disc may become scratched (although not enough to make it unusable) depending on how you handle it and other conditions in the usage environment. These scratches are not an indication of a problem with the player. 2 JCD2006 INSTALLATION Before You Begin 1. Disconnect Battery Before you begin, always disconnect the battery negative terminal. [. . . ] 53 If it is locked into position, use the removal Screw Stud keys (supplied) to disengage it. The removal keys are depicted in "Removing the Unit" on page 3. Check the dashboard opening size by sliding the mounting sleeve into it. If the opening is not large enough, carefully cut or file as necessary until the sleeve easily slides into the opening. Check that there will be sufficient space behind the dashboard for the radio chassis. Locate the series of bend tabs along the top, bottom and sides of the mounting sleeve. With the sleeve fully inserted into the dashboard opening, bend as many of the tabs outward as necessary to firmly secure the sleeve to the dashboard. Place the radio in front of the dashboard opening so the wiring can be brought through the mounting sleeve. Follow the wiring diagram carefully and make certain all connections are secure and insulated with crimp connectors or electrical tape to ensure proper operation. secure part of the dashboard Screw Stud Hex Nut (5mm) either above or below the radio using the screw and plain Spring Washer washer provided. CAUTION: The rear of the radio must be supported with the strap to prevent damage to the dashboard from the weight of the radio or improper operation due to vibration. Re-attach the front panel to the chassis and test radio operation by referring to the operating instructions for the unit. Ground Connect to ground terminal or clean unpainted metal part of chassis. 11 BLACK YELLOW Memory / Battery Connect to battery or 12 volt power source that is always live. Accessory / Ignition Connect to existing radio wire or radio fuse. RED LEFT FRONT WHITE-BLACK LF- RIGHT FRONT GREY-BLACK RFGREY RF+ PIN 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 WIRE COLOR GREY / BLACK GREY VIOLET VIOLET/BLACK EMPTY GREEN GREEN / BLACK RED BLACK RED WHITE WHITE / BLACK EMPTY BLUE YELLOW BLACK EMPTY EMPTY EMPTY WHITE FUNCTION / LABEL RIGHT FRONT SPEAKER ( ) RIGHT FRONT SPEAKER (+) RIGHT REAR SPEAKER (+) RIGHT REAR SPEAKER ( ) N/A LEFT REAR SPEAKER (+) LEFT REAR SPEAKER ( ) IGNITION (ACC) REAR PRE-AMPLIFIER LINE OUT COMMON RIGHT REAR PRE-AMPLIFIER LINE OUT LEFT FRONT SPEAKER (+) LEFT FRONT SPEAKER ( ) N/A POWER ANTENNA BATTERY (+) CHASSIS GROUND N/A N/A N/A LEFT REAR PRE-AMPLIFIER LINE OUT WHITE LF+ LEFT REAR GREEN-BLACK LR- RIGHT REAR VIOLET-BLACK RR- GREEN LR+ VIOLET RR+ 5 JCD2006 BASIC OPERATION Display (DISP) Press the DISP button (10) to view the clock. The LCD will display the clock for 5 seconds and then return to the previous display mode. Clock Adjustment With the clock displayed, press the DISP button (10) until the LCD flashes. Press the TUNE up >>| (7) button to adjust the minutes or the down TUNE |<< button to adjust the hour. CD PLAYER / RECEIVER Reset JCD2006 INT AS PS 40 WATTS X 4 RDM RPT CH CD -I N After releasing the control panel, use a pencil or any non-metallic object to press and hold the RESET button for five seconds to reset the main unit. The reset button should be activated for the following reasons: · · · initial installation of the unit when all wiring is completed function buttons do not operate error symbol on the display RESET BUTTON 13 14 15 16 17 18 19 Control Panel Release ( ) NOTE: If after pressing the RESET button the unit still does not function normally, use a cotton swab soaked in isopropyl alcohol to clean the socket on the back of the control panel. Press the release button (8) to release the control panel. (See "Detachable Control Panel (DCP)" on page 4. ) Audio Menu Press the volume control button (5) to access the Audio Menu. You can navigate through the Audio Menu items by pressing the volume control button repeatedly. Once the desired menu item appears on the display, adjust that option by turning the volume control knob within 5 seconds. The unit will automatically exit the Audio Menu after five seconds of inactivity. Volume Level Use the volume control knob to adjust the Volume level from "00" (lowest) to "46" (highest). [. . . ] Press the TUNE |<< button to return to the beginning of the current track or press twice to skip to the previous track. Press and hold the TUNE >>| or |<< button (7) for more than 1 second to fast forward or fast reverse through the disc. Play/Pause Disc Playback (1 PAU) Press the 1 PAU button (13) to suspend disc play. Intro Scan (2 SCN) Press the 2 SCN button (14) to play the first 10 seconds of each track sequentially. [. . . ]