User manual JONSERED CS 2159

[. . . ] Operators manual Please read the operator's manual carefully and make sure you understand the instructions before using the machine. CS 2156 CS 2159 KEY TO SYMBOLS Symbols on the machine: WARNING!Careless or incorrect use can result in serious or fatal injury to the operator or others. Please read the operator's manual carefully and make sure you understand the instructions before using the machine. Always wear: · · · Approved protective helmet Approved hearing protection Protective goggles or a visor WARNING! [. . . ] For longer periods of storage or for transport of the chain saw, the fuel and chain oil tanks should be emptied. Ask where you can dispose of waste fuel and chain oil at your local petrol station. Ensure the machine is cleaned and that a complete service is carried out before long-term storage. The bar guard must always be fitted to the cutting attachment when the machine is being transported or in storage, in order to prevent accident contact with the sharp chain. Even a non-moving chain can cause serious cuts to yourself or persons you bump into with an exposed chain. ! WARNING!Be aware of the risks of fire, explosion and those associated with inhalation. · · · · Long-term storage Empty the fuel/oil tanks in a well ventilated area. See instructions under the heading Maintenance schedule. 18 ­ English STARTING AND STOPPING Starting and stopping Warm engine Use the same procedure as for starting a cold engine but without setting the choke control in the choke position. The correct choke/start throttle setting is obtained by moving the choke control to the choke position and then pushing it in again. ! WARNING!Note the following before starting: The chain brake must be engaged when the chain saw is started to reduce the chance of contact with the moving chain during starting. Never start a chain saw unless the bar, chain and all covers are fitted correctly. Make sure you have a secure footing and that the chain cannot touch anything. Keep people and animals well away from the working area. H Starting Cold engine Starting: The chain brake must be engaged when the chain saw is started. Activate the brake by moving the front hand guard forwards. Grip the front handle with your left hand. Hold the chain saw on the ground by placing your right foot through the rear handle. Pull the starter handle with your right hand and pull out the starter cord slowly until you feel a resistance (as the starter pawls engage) then pull firmly and rapidly. Do not pull the starter cord all the way out and do not let go of the starter handle when the cord is fully extended. This can damage the machine. Ignition; choke: Set the choke control in the choke position. Start throttle: The correct choke/start throttle setting is obtained by moving the control to the choke position. Push in the choke control as soon as the engine fires and keep pulling until the engine starts. When the engine starts, quickly apply full throttle; the throttle start lock will automatically disengage. As the chain brake is still engaged the speed of the engine must be set to idling as soon as possible, this is achieved by quickly disengaging the throttle lock. This prevents unnecessary wear to the clutch, clutch drum and brake band. [. . . ] A thermostat regulates the heating so that the carburetor always has the right working temperature. For temperatures below -5°C and/or in snow conditions there is also: · a special cover (A) for the starter housing English ­ 35 MAINTENANCE Maintenance schedule The following is a list of the maintenance that must be performed on the machine. Weekly maintenance On chain saws without a catalytic converter, check the cooling system weekly. Replace when less than 0. 6 mm (0, 024 inch) remains at the most worn point. Check that the components of the throttle Check the starter, starter cord and return Check the clutch centre, clutch drum and control work safely. throttle control. ) Clean the chain brake and check that it operates safely. [. . . ]