User manual JONSERED LT 2213 C

[. . . ] Please read these instructions carefully and make sure you understand them before using this machine. ⷠNever allow children or people unfamiliar with the instructions to use the lawnmower. ⷠNever mow while people, especially children, or pets are nearby. ⷠKeep in mind that the operator or user is responsible for accidents or hazards occurring to other people or their property. [. . . ] If the bagger becomes disengaged during cutting, the engine will shut off. Quick lifting/lowering of the cutting unit Pull the lever backwards to quickly lift the cutting unit when passing over irregularities in the lawn, etc. During transportation the cutting unit shall be in the highest position. There are four different positions for the ignition key: OFF All electric current broken. Reverse Operation System (ROS) - Allows operation of mower deck or other powered attachment while in reverse (See section 5 - "Driving") WARNING!Never leave the key in the ignition lock when leaving the machine on its own. To release the parking brake all that is necessary is to push down the brake pedal. Do not smoke when filling with petrol or fill up when the engine is warm. The combined oil refilling cap and the oil stick is accessible when the bonnet is lifted forwards. If more oil is needed add SAE 30 oil to the "FULL " marking. SAE 5W-30 oil should be used during the winter (below freezing point). Make sure that the cutting unit is in the transport position (top position) and that the lever for connection/disconnection of the cutting unit is in the disconnection position. If the engine will not start, wait about 10 seconds before the next try. Let the ignition key return to the "ON" position when the engine has started Push the gas control to the required speed. The machine is equipped with a safety switch which immediately breaks the current to the engine if the driver leaves the seat with engine running and with the connection/ disconnection lever in position "connection". Choose a driving speed which suits the terrain and required cutting results. Any attempt by the operator to travel in the reverse direction with the attachment clutch engaged will shut off the engine unless ignition key is placed in the ROS "ON" position. Backing up with the attachment clutch engaged while mowing is strongly discouraged. Turning the ROS "ON", to allow reverse operation with the attachment clutch engaged, should only be done when the operator decides it is necessary to reposition the machine with the attachment engaged. With engine running, turn ignition key counterclockwise to ROS "ON" position. ⷠMove gear shift lever to reverse (R) position and slowly release clutch/brake pedal to start movement. ⷠPosition a container under oil drain extension to catch oil. [. . . ] ⷠHold adjustment nut in position with wrench and tighten jam nut securely against adjustment nut. The transaxle should be in neutral when the gear shift lever is in neutral (N) (lock gate) position. The adjustment is preset at the factory; however, if adjustment is needed, proceed as follows: · NOTE: If additional clearance is needed to get to adjustment bolt, move mower deck height to the lowest position. Dismantle the cutting unit as described previously Engage the parking brake and work off the belt upwards from the pulley (1), the clutch pulley (2) and the engine's drive wheel (3). [. . . ]