User manual JUNO JDA 5271 X

[. . . ] . page 60 TECHNICAL SPECIFICATIONS DIMENSIONS Width Height Max depth Max depth with door open Voltage cm 46, 6 cm 81, 8 - 87, 8 cm 55, 5 cm 115 220-230V/50Hz 200 W 2800 W 3000 W ELECTRICAL CONNECTION MOTOR RATING DURING WASHING POWER OF HEATING ELEMENT OVERALL POWER WATER SUPPLY PRESSURE minimum maximum 5 N/cm2 80 N/cm2 9 CAPACITY (STANDARD IEC PLACE SETTINGS) CONSUMPTION: Water Electricity 18 lt 1. 2 kW/h This appliance complies with the following E. E. C. Directives: - 73/23 of 19. 2. 73 (Low Voltage Directive) and subsequent modifications; - 89/336 of 3. 5. 89 (Electromagnetic Compatibility Directive) and subsequent modifications. PID30GB 47 WARNINGS It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is left with the appliance in order that the new owner can get to know the functioning of the appliance and the relevant warnings. You MUST read them carefully before installing or using the appliance. s s Under no circumstances should you attempt to repair the machine yourself. [. . . ] You are reminded of this by the Salt Refill Indicator Light on the control panel which will illuminate when the salt has finished. The salt container has always some water inside which will normally overflow when refilling with salt. Important: The Salt Refill Indicator Light on the control panel can remain illuminated for 2-6 hours after the salt has been replenished, assuring the dishwasher remains on. If you are using salts that take longer to dissolve then this can take longer. Caution Only fill with salt just before starting one of the complete washing programmes (not the Rinse and Hold programme). This will prevent any grains of salt or salty water, which may have been spilled, remaining on the bottom of the machine for any period of time. This could cause corrosion. 65° pushbutton 65° pushbutton 55° pushbutton 55° pushbutton To select a different level, proceed as follows: - Press the NORMAL 65° and QUICK 55° programme buttons simultaneously for about 5 seconds until the short "instruction accepted" signal is heard. Remember that insufficient quantities of detergent will produce poor washing results whereas an excessive amount of detergent does not improve washing results and is also wasteful. Using no more than the correct amount of detergent also contributes to reducing pollution. BR04 A Caution: Do not put liquid detergent into the rinse aid compartment Use of Detergent Before starting any of the dishwashing programmes, except for the Rinse and Hold programme, load the detergent in the dispenser. Use only tablets, powder or liquid detergents specifically designed for domestic dishwashers. Unsuitable detergents (such as those for washing by hand) do not contain the right ingredients for machine washing and hamper correct functioning of the machine. Phosphate free detergents with enzymes These new detergents, although welcome from an ecological point of view, react far more susceptibly to water hardness than conventional products. This programme does not require any detergent. / 10 65° / 1 level dessert spoonful (10 g) Prewash up to 55°C Main wash up to 65°C 2 cold rinses 1 hot rinse Hot air drying 78 1 cold rinse (to avoid food scraps from sticking to the dishes). 0, 1 11 INTENSIVE 65° Heavily soiled, also dried up and containing starch (i. e. (20 g) 2 level dessert spoonfuls 1, 6 23 NORMAL 65° 65° Pots - Pans Crockery 2 level dessert spoonfuls Half desert spoonful (5 g) (20 g) Normally or heavily soiled, also dried up and/or containing starch (i. e. pasta, rice, semolina, potatoes, egg, sauces, roast). 68 1, 2 18 PTP30GB 55 55° Cold prewash Main wash up to 65°C 1 cold rinse 1 hot rinse Hot air drying ECONOMY 55° Crockery (20 g) Normally soiled not dried up and starchless (i. e. meat, cooked or uncooked vegetables, milk, coffee, drinks). 2 level dessert spoonfuls Half dessert spoonful (5 g) Cold prewash Main wash up to 55°C 1 cold rinse 1 hot rinse Hot air drying 64 1, 0 18 * QUICK 55° WASH 55°C 1 heaped desert spoonful (15 g) Main wash up to 55°C 1 cold rinse 1 hot rinse Lightly soiled, not dried up and Crockery starchless (i. e. Due to the shortness of this programme, no drying phase is provided. / 40 0, 8 17 Testing programme according to IEC 436/DIN 44990 - NORMAL 65° Programme with detergent type A and ECONOMY 55° Programme with detergent type B; * This is a special programme for quick washing (approx. 40 minutes) a full load of lightly soiled dishes, glasses and crockery (except pots) so that you may re-use them promptly. ** These specifications are indicative values and depend on the pressure and temperature of the water, and also on voltage modifications. - Standard place settings 9; - Recommended quantity of detergent: 20 g in the dispenser 5 g over the dispenser lid. ENGLISH Operating Sequence 1 Check that the filters are clean (see clearing instructions) 6 Start the programme Open the water supply. The indicator light which corresponds to the programme under way is now permanently on. Caution If you need to stop the dishwasher at any moment during the wash programme, switch the appliance off at the plug; open the door and press the ON/OFF Button In general it is not advisable to open the door while the machine is working; if the door is opened however, a safety device ensures that the machine stops. 2 Check that there is salt and rinse aid 3 Load the dishes Remove larger scraps of food. Pull the lower basket out and arrange the saucepans, plates and cutlery in it. Pull the upper basket out and arrange the plates, saucers, glasses and cups etc. [. . . ] Eliminate the kink (see instructions for connection to the water drain). Switch off the dishwasher, then switch it back on and start the wash programme. If the alarm signal reappears, call the Technical Service Centre. PRA29GB s s s 58 Visible lime deposits or white film on the dishes s There is no salt or the softener has not been adjusted to the hardness of the water. The rinse aid has run out or too little is being used. s If, after the above checks, the fault persists, call your nearest Service Centre, indicating the fault, the appliance model (Mod. ), the product number (Prod. [. . . ]