User manual JUNO JDF2940S

[. . . ] -- The best performance of the unit is obtained in the exhaust mode, therefore in the limits of the possibilities it is advised to use the external exhaust (suction) type. The air is filtered through a carbon filter and recirculated into the room through the grid on the higher part of the chimney. If the hood is not supplied with carbon filter, then it must be ordered and mounted. Before completing any connection, make sure the house voltage corresponds with the voltage indicated on the label affixed inside the hood. [. . . ] Before completing any connection, make sure the house voltage corresponds with the voltage indicated on the label affixed inside the hood. the hood is supplied with a standard plug; connect it to a correspondingly standard socket. In the case is intended to connect the appliance permanently to the mains after having removed the plug supplied, must be fitted a two-pole switch conforming to regulations with an opening distance between contacts of not less than 3mm. The manufacturers are not liable for any problems caused by the user's failure to observe the above instructions. -- The hood cannot be connected to flues of other appliances that run on energy sources other than electricity. -- When the hood is used at the same time of other appliances that run on energy sources other than electricity, provision must be made for an adequate supply of air. A) Place the top edge of the template at the centre of the lower edge of the cabinet and mark off four holes on the wall. 2) c) From below, fit the upper casing of the hood in the cabinet opening flush to the wall until it stops and fasten it to the wall with two 5 x 45 mm screws in the upper plugs previously inserted in the wall (Fig. 5 x 13 mm wood screws from inside the upper casing of the hood in the lower edge of the cabinet. D) With 4 guide pins insert the lower exhaust part to the upper part and fasten with the two clamps positioned one to the right and one to the left. At the start of this procedure, only the F Led will blink, after 3 seconds have passed, the C Led will begin to blink, as well to indicate that the saturation control device for the charcoal filter has been activated. Speed 1 LED Speed 2 LED and grease filter saturation LED (flashes) Speed 3 LED and carbon filter saturation LED (flashes) Intensive speed indicator LED Intensive speed ON switch This speed should be used when the concentration of cooking fumes or odours is particularly strong (for example when frying, cooking fish etc. The fast speed will run for about 5 minutes and then return to the speed previously set automatically (1, 2 or 3), or switch off if no speed was selected. To turn off the fast speed, before the end of the 5 minutes, press button A or button B. The Led marked F flashes to warn you when the grease filter needs to be cleaned. If the hood fails to operate correctly, briefly disconnect it from the mains power supply for almost 5 sec. Then plug it in again and try once more before contacting the Technical Assistance Service. Once the grease filters have been cleaned or the charcoal filter replaced, press the A button for approximately 3 seconds until you hear the (beep): Now fix it into place using the two hooks G of the carbon filter. 3: -- To dismount, press the two buttons A and pull gently forwards to remove the filter from its housing. Failure to observe the rules for cleaning the appliance and changing and cleaning the filters may cause fires. [. . . ] Once the grease filters have been cleaned or the charcoal filter replaced, press the A button for approximately 3 seconds until you hear the (beep): Now fix it into place using the two hooks G of the carbon filter. 3: -- To dismount, press the two buttons A and pull gently forwards to remove the filter from its housing. Failure to observe the rules for cleaning the appliance and changing and cleaning the filters may cause fires. Before performing any maintenance operation, disconnect the hood from the electricity. [. . . ]