User manual JUNO JDK8130W

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual JUNO JDK8130W. We hope that this JUNO JDK8130W user guide will be useful to you.


JUNO JDK8130W : Download the complete user guide (80 Ko)

You may also download the following manuals related to this product:

   JUNO JDK8130W (81 ko)
   JUNO JDK8130W (94 ko)

Manual abstract: user guide JUNO JDK8130W

Detailed instructions for use are in the User's Guide.

[. . . ] We suggest to use Ø 150 mm exhausting pipe. -- No food must be cooked flambé underneath the hood. The use of an unprotected flame is dangerous for the filters and could cause fires. [. . . ] -- When the hood is used at the same time of other appliances that run on energy sources other than electricity, provision must be made for an adequate supply of air. Mounting the hood - Fig. Hang the hood on the hooks and adjust the position of the hood using the two screws on the bottom of the hooks (4). Remove the metal filters (3) and from the inside of the hood mark two point (2). Fit two Ø8mm wall dowels, Hang again the hood and fix the hood definitively with two screws 5X45 (5) from the inside of thehood. Operation The hoods JDK 7130, JDK 8130, JDK 7240 are JDK 8240 are provided with a motor with three speed. For the best performance, we recommend using the low speeds in normal conditions and the high speeds in particular cases of strong odour and vapour concentration. We recommend starting up the hood a few minutes before cooking and keeping it running until all the odours have been eliminated. Maintenance Before performing any maintenance operation, disconnect the hood from the electricity. Mounting the chimney e. Fix the chimney support (7) with two screws 5 x 45 mm (8) and two wall dowels (6) on the wall close to the ceiling. For exhausting version: Fit the connection ring on the top of the hood with two screws Ø 3, 5 x 6, 5 mm (9S) then fit an axhausting pipe long enough to reach the outside (10S). For recycling version: first insert the fixing nooses of the deflector (K) on the rear slot (9K) then fix definitively the deflector (K) on the top of the hood with two screws Ø 3, 5 x 6, 5 mm on the front holes (9K). Fit the chimney (12) and fix it on the chimney support with two screws 3, 0 x 9 mm (13). [. . . ] Before calling for Repair Service because the hood fails to light up, make sure the lamp is well-inserted. Cleaning To clean the outside of the hood use a cloth moistened with denatured alcohol or neutral liquid detergents. Never use products containing abrasive. Attention Failure to observe the rules for cleaning the appliance and changing and cleaning the filters may cause fires. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE JUNO JDK8130W




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual JUNO JDK8130W will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.