User manual JUNO JDK9570E

[. . . ] To turn off the fast speed, before the end of the 5 minutes, press button A or button B. OFF lamp button ON lamp button Maintenance Before performing any maintenance operation, isolate the hood from the electrical supply by switching off at the connector and removing the connector fuse. Or if the appliance has been connected through a plug and socket, then the plug must be removed from the socket. Metal grease filter This holds back suspended grease particles. The metal grease filter lasts forever and must be washed either by hand or in the dishwasher (65°C) with suitable detergents. [. . . ] Hood featuring control panel with keypad The grease filters must be washed at least once a month. Hood with electronic control panel ìThe metal grease filters must be washed at least once a month and anyhow whenever the metal grease filter saturation led (Speed 2 LED) indicates the saturation of the filter. This LED flashes to warn you that the metal grease filters must be cleaned. Once the grease filters have been cleaned, If the hood fails to operate correctly, briefly disconnect it from the mains power supply for almost 5 sec. Then plug it in again and try once more before contacting the Technical Assistance Service. 10 GB press button A and button H at the same time for about two seconds until you hear the acoustic signal (beep): the grease filter saturation led F will now stop flashing. Carry out the above steps in reverse order to put the filters back after having washed them. Cleaning To clean the outside of the hood use a cloth moistened with denatured alcohol or neutral liquid detergents. Wipe brushed stainless steel in the same direction as the brushing to avoid scratching. Attention Failure to observe the instructions for cleaning the appliance and changing and cleaning the filters may cause fires. Therefore, we recommend observing these instructions. Carbon filter ("recirculation mode only", see next pages) The carbon filter cannot be washed nor regenerated. -- The manufacturers refuse to accept any responsibility for damage to the hood or its catching on fire because of failure to observe the above instructions. -- A constant maintenance guarantees a good 11 GB operation and good performance of the unit. -- The best performance of the unit is obtained in the exhaust mode, therefore in the limits of the possibilities it is advised to use the cooker hood in this way. -- The best performances are obtained with short pipes and with few curves. -- In order to eliminate loss of heat towards the outside; in the winter period the unit can be used in the recycling (filtering) mode. -- In the event of fire, disconnect immediately the unit from the power supply remove the source of fire (pots, etc. ). Systems available Two systems are available: Exhaust mode Vapours are extracted outside through an exhausting pipe that is affixed to the connection ring above the hood (Fig. Diameter of the exhausting pipe must be equal to that of the connection ring. In the horizontal runs the duct must be slightly slanted (about 10°) and directed upwards to vent the air easily from the room to the outside. [. . . ] If the hood is supplied with carbon filter, then it must be removed. Installation - Fig. 4 When installed, the distance between hood and burners must be not less than 65 cm. above gas or mixed-fuel burners. Recirculation mode (K - See the installation diagram) The air is filtered through a carbon filter and recirculated into the room through the grid on the higher part of the chimney. [. . . ]