User manual JUNO JDS3530B

[. . . ] 1) According to your installation the pipe can be directed either towards the ceiling or towards the walls (Fig. Use the rear exhaust hole if air may be pushed to the outside by means of a hole in the back wall (Fig. [. . . ] -- The best performance of the unit is obtained in the external exhaust model (suction), therefore in the limits of the possibilities it is advised to use the external exhaust (suction) type. I, fix the hood to the hooks F, check that the hood is at the right height (to eventually adjust the height work on the screws L (Fig. For a further adjustment act on the screws J through the holes N (fig. Apply the scheme N2I on the side of the right cupboard, so that the side B matches the front part of the cupboard (disregard the thickness of the flap) and drill two holes 2, 5 mm diameter in the points B1 and B2 (Fig. Then apply the same scheme on the side of the left cupboard, matching the side C with the front part of the cupboard (disregard the thickness of the flap) and drill two holes 2, 5 mm diameter in the points C1 and C2 (Fig. Replace the door, inserting it first in the upper then in the lower slides, turn the rear locking knobs P (Fig. Adjust the angle frame tightly to the wall, making use of the apposite screws M (Fig. Before completing any connection, make sure the house voltage corresponds with the voltage indicated on the label affixed inside the hood. the hood is supplied with a standard plug; connect it to a correspondingly standard socket. In the case is intended to connect the appliance permanently to the mains after having removed the plug supplied, must be fitted a two-pole switch conforming to regulations with an opening distance between contacts of not less than 3mm. The manufacturers are not liable for any problems caused by the user's failure to observe the above instructions. Place the expansion plugs G supplied with the hood in the lower holes (Fig. [. . . ] Always replace burnout bulbs with oliveshaped max 40 Watt (E14) bulbs. -- Before calling for Repair service because the hood fails to light up, make sure the bulbs are screwed in tightly. [. . . ]