User manual JUNO JEC700W

[. . . ] ⷠTake utmost care when handling your appliance so as not to cause any damages to the cooling unit with consequent possible fluid leakages. ⷠThe appliance must not be located close to radiators or gas cookers. There must be adequate ventilation round the back of the appliance and any damage to the refrigerant circuit must be avoided. Do not use other electrical appliances (such as ice cream makers) inside of refrigerating appliances. [. . . ] It is advisable to wait at least two hours before connecting the appliance to allow the oil to flow back in the compressor. ⷠThere are working parts in this product which heat up. Always ensure that there is adequate ventilation as a failure to do this will result in component failure and possible food loss. This appliance does not contain gasses which could damage the ozone layer, in either its refrigerant circuit or insulation materials. The appliance shall not be discarded together with the urban refuse and rubbish. Avoid damaging the cooling unit, especially at the rear near the heat exchanger. Information on your local disposal sites may be obtained from municipal authorities. The materials used on this appliance marked by the symbol are recyclable. Before using the appliance for the first time, wash the interior and all internal accessories with luke-warm water and some neutral soap so as to remove the typical smell of a brandnew product, then dry thoroughly. Do not use detergents or abrasive powders, as these will damage the finish. Pilot light Thermostat knob Super control light Normal/Super push button/ Reset sound signal alarm Warning light Insert the plug into the wall socket. To help you make the most of the freezing process, here are some important hints: · The maximum quantity of food which can be frozen in 24 hrs. No further food to be frozen should be added during this period; · Prepare food in small portions to enable it to be rapidly and completely frozen and to make it possible subsequently to thaw only the quantity required; · Wrap up the food in aluminium foil or polythene and make sure that the packages are airtight; · Do not allow fresh, unfrozen food to touch food which is already frozen, thus avoiding a rise in temperature of the latter; · Water ices, if consumed immediately after removal from the freezer compartment, can possibly cause the skin to be freeze burnt; · It is advisable to show the freezingin date on each individual pack to enable you to keep tab of the storage time; · Do not put carbonated liquids (fizzy drinks, etc. To obtain the best performance from this appliance, you should: · Make sure that the commercially frozen foodstuffs were adequately stored by the retailer; · Be sure that frozen foodstuffs are transferred from the foodstore to the freezer in the shortest possible time; · Not open the door frequently or leave it open longer than absolutely necessary. ⷠOnce defrosted, food deteriorates rapidly and cannot be refrozen. ⷠDo not exceed the storage period indicated by the food manufacturer. Warning This appliance contains hydrocarbons in its cooling unit; maintenance and recharging must therefore only be carried out by authorized technicians. Remove all food; defrost and clean the interior and all accessories; leave the door ajar to allow air to circulate to prevent unpleasant smells. The freezer compartment, however, will become progressively covered with frost. This should be removed with the special plastic scraper provided, whenever the thickness of the frost exceeds 4 mm. During this operation it is not necessary to switch off the power supply or to remove the foodstuffs. Never use sharp metal tools to scrape off frost from the evaporator as you could damage it. [. . . ] From the plastic cover (E), which is used to cover the hinge with the pivot pin, you must take away the part as indicated in the drawing. This operation is made easer since there is, in the internal part of the cover hinge lid a groove that facilates the removal of this coomponent. Separate parts Ha, Hb, Hc, Hd as shown in the figure Place guide (Ha) on the inside part of the furniture door, up and down as shown in the figure and mark the position of external holes. Remove the brackets and mark a distance of 8 mm from the outer edge of the door where the nail must be fitted (K). [. . . ]