User manual JUNO JKI 1433

[. . . ] Manufacturers' storage recommendations should be strictly adhered to. Always ensure that there is adequate ventilation as a failure to do this will result in component failure and possible food loss. Before any cleaning or maintenance work is carried out, be sure to switch off and unplug the appliance. [. . . ] Directives: - 73/23 EEC of 19. 2. 73 (Low Voltage Directive) and subsequent modifications; - 89/336 EEC of 3. 5. 89 (Electromagnetic Compatibility Directive) and subsequent modifications. A Cleaning the interior Before using the appliance for the first time, wash the interior and all internal accessories with lukewarm water and some neutral soap so as to remove the typical smell of a brand-new product, then dry thoroughly. Do not use detergents or abrasive powders, as these will damage the finish. D265 If after having carried out the operation described in section 2 there is still some space left between the appliance and the kitchen unit, fit the trimming provided together with the appliance on the stop strip (A). 11 Fig. 8 Open the door and push the appliance against the side of kitchen furniture opposite to that of appliance hinges. D Fasten the appliance with 4 screws provided in the kit inC cluded with the apD727 pliance. 5 8mm PR34 Open both the appliance door and that of the kitchen unit to approx. Hold the doors of the appliance and the unit together and mark the holes. Fig. 9 Press in the joint covers between the appliance and the kitchen furniture. D724 Fig. Replace the little plates over the runners and screw in the screws provided (3. 5x16 mm). For the alignment of the kitchen unit door, PR35 if necessary, use the clearance size of the slotted holes. At the end of the procedure, check that the doors of the appliance and the kitchen unit open properly. Apply covers (B) on joint cover lugs and into hinge holes. Inner door reversal (Fig. Remove catch (3) by undoing the screw and refit it on the opposite side. 7 A 20m m PR33 Position the runners (A) at the top and bottom of the inside of the kitchen unit as shown in Fig. After preparing the holes, screw the runners to the kitchen unit door using 3. 5x16 mm screws. 4 3 2 D164 5 1 12 USE Operation - regulating the temperature Turn the thermostat dial, positioned at the top right of the compartment, clockwise to the required position (beyond the «O» position); the most suitable setting is between 2 and 4. The temperature is automatically regulated; it can be increased by turning the dial towards the lower numbers and vice versa. When selecting the correct position, remember that the internal temperature depends on the following factors: ambient temperature, how often the door is opened, the amount of food stored, where the appliance is installed. To switch off, turn the dial until it coincides with the «O» symbol. [. . . ] After two or three hours, reload the previously removed food into the compartment. Important: A temperature rise of the frozen food packs, during defrosting, may shorten their safe storage life. 14 MAINTENANCE Unplug the appliance before carrying out any maintenance operation. Interior light The light inside the refrigerator compartment is easy to get at through the opening in the light holder. If the light does not go on when the door is open, check that it is screwed into place properly. [. . . ]