User manual JUNO JKI 4065

[. . . ] This symbol and numbered instructions guide you step by step in the operation of the appliance. . . . . . 1 3 2 Supplementary information regarding operation and practical applications of the appliance appear after this symbol. Tips and notes concerning economical and environmentally sound use of the appliance are marked with the cloverleaf. Explanations of the technical terminology used in the operating instructions can be found at the end in the section "Technical Terminology". [. . . ] The warmed air must be able to be exhausted upwards through the air shaft (min. 200 cm2) on the furniture back. 33 Installation option 2: Operation of E-appliances is possible even without a ventilation opening in the furniture plinth. The fresh air able to enter under the appliance is sufficient for ventilation. The warmed air must be able to be exhausted upwards through the air shaft (min. If the appliance is ventilated without a plinth opening, however, the energy consumption may differ from that specified in the brochure. In order not to impair the function of the appliance, never cover or obstruct the ventilation openings. Installation See installation instructions supplied. Please check whether, after installing your appliance and especially after rehingeing the door, the door seal seals right round. An untight door seal may lead to heavy frosting and thereby to a higher power consumption (see also , , What to do if. . . "). Electrical connection Before initial start-up, refer to the appliance rating plate to ascertain if supply voltage and current values correspond with those of the mains at the installation location. 220 to 240 volts alternating current, 50 Hertz) The rating plate is inside the appliance on the left. A correctly installed, earthed socket is required for the electrical supply. If the socket is not accessible once the appliance is built in, the electrical installation must include suitable means of isolating the appliance from the mains (e. g. Place only unopened bottles or cans horizontally. 39 Interior Accessories Variable Storage Box (not on all models, design may differ depending on the model) Some models are equipped with a variable storage box which is fitted under a door shelf compartment and can be slid sideways. To change the position of the storage box; lift the shelf compartment with the box upwards and out of the holders in the door and remove the retaining bracket out of the guide under the shelf compartment. Reverse the above operation to insert the shelf at a different height. The variable box can be hung from a storage shelf in the refrigerator compartment: 0 1. Pull the storage shelf forward until it can be tipped up or down and removed. Hang the retaining bracket on the taper of the shelf and slide the storage shelf back into the guides. Bottle Holder (not included with all models) Some models are supplied with a bottle holder in the bottle compartment. This is used to prevent individual bottles from falling over and can be slid sideways. 40 Correct Storage For physical reasons, there are different temperature regions in the fridge. Warmer regions are the top storage shelf, the vegetable basket and the storage compartments on the door. The arrangement example shows at which places in the refrigerator suitable temperatures for various types of foods exist. Tip: Food in the fridge should always be covered or packaged, to prevent drying and tainting of other food. The following are suited for packaging: ­ Polyethylene airtight bags and wraps; ­ Plastic containers with lids; ­ Special plastic covers with elastic; ­ aluminium foil. Defrosting The fridge defrosts automatically The rear wall of the fridge covers with frost when the compressor is running, and defrosts when the compressor is off. [. . . ] See the "Cleaning and Maintenance" section. 44 Changing the light bulb Warning!Before changing the light bulb, switch off the appliance and unplug it, or pull the fuse or the circuit breaker. To switch off the appliance, turn the temperature regulator to position "0". To change the light bulb, undo the cross head screw and remove the light bulb cover. [. . . ]