User manual JUNO KD6020SWEL

[. . . ] Take utmost care when handling your appliance so as not to cause any damages to the cooling unit with consequent possible fluid leakages. The appliance must not be located close to radiators or gas cookers. There must be adequate ventilation round the back of the appliance and any damage to the refrigerant circuit must be avoided. Do not use other electrical appliances (such as ice cream makers) inside of refrigerating appliances. [. . . ] Always ensure that there is adequate ventilation as a failure to do this will result in component failure and possible food loss. This appliance does not contain gasses which could damage the ozone layer, in either its refrigerant circuit or insulation materials. The appliance shall not be discarded together with the urban refuse and rubbish. Avoid damaging the cooling unit, especially at the rear near the heat exchanger. Information on your local disposal sites may be obtained from municipal authorities. The materials used on this appliance marked by the symbol are recyclable. Before using the appliance for the first time, wash the interior and all internal accessories with luke-warm water and some neutral soap so as to remove the typical smell of a brandnew product, then dry thoroughly. Do not use detergents or abrasive powders, as these will damage the finish. In this case the dial must be set to a higher temperature to allow automatic defrosting and therefore reduced energy consumption. Open the refrigerator door and turn the thermostat knob, clockwise, beyond the «O» (STOP) position. Do not store warm food or evaporating liquids in the refrigerator; · Do cover or wrap the food, particularly if it has a strong flavour. Whether the upper or lower value of the indicated storage time is valid depends on the quality of the foods and pre-treating before freezing. Warning This appliance contains hydrocarbons in its cooling unit; maintenance and recharging must therefore only be carried out by authorized technicians. Clean the condenser (black grill) and the compressor at the back of the appliance with a brush or a vacuum cleaner. This operation will improve the performance of the appliance and save electricity consumption. When the appliance is not in use for long periods, take the following precautions: · Remove the plug from the wall socket; · Leave the door ajar to allow air to circulate to prevent unpleasant smells. The light bulb inside the refrigerator compartment can be reached as shown in the figure. If the light does not come on when the door is opened, check that it is screwed into place properly. Frost is automatically eliminated from the evaporator of the refrigerator compartment every time the motor compressor stops, during normal use. The defrost water drains out through a trough into a special container at the back of the appliance, over the motor compressor, where it evaporates. It is important to periodically clean the defrost water drain hole in the middle of the refrigerator compartment channel to prevent the water from overflowing and dripping onto the food inside. Use the special cleaner provided, which you will find already inserted into the drain hole. [. . . ] This operation is made easer since there is, in the internal part of the cover hinge lid a groove that facilates the removal of this coomponent. Separate parts Ha, Hb, Hc, Hd as shown in the figure Place guide (Ha) on the inside part of the furniture door, as shown in the figure and mark the position of external holes. Should the lining up of the furniture door be necessary, use the clearance of slots. put together the appliance door and the furniture door and mark the holes as indicated in the figure. [. . . ]